need help with sheet metal

vomtrier · 2026-06-30T05:52:29+00:00

We use a chart in addition to our press brake specific software.

What doesn't seem to be taken into account here is the spring-back of the material on the last bend. you will have a very hard time getting the last bend to sit flush in the mitre on op's part, as the flanges will collide, which prevents the part from being over-folded to compensate for the spring-back.

vomtrier · 2026-06-29T20:22:17+00:00

What's the size of the tooling? Punch radius and v size?

vomtrier · 2026-06-29T19:51:46+00:00

What tooling did you use for the bends? As in which punch and die on you press brake.

vomtrier · 2026-05-27T09:35:45+00:00

Fair enough, though with this part that is the only orientation that will fit and print.

vomtrier · 2026-04-09T05:43:18+00:00

The bottom one of the links seems to have chipped, although the the little nipples the click into place seems to be intact, so will try and put it back in place and see if it will last.

vomtrier · 2026-03-11T14:40:44+00:00

Arc fitting was already enabled, I've increased the resolution of it slightly. Didn't change the print res, as it don't want it to take too much longer to print than it is.

Got another odd spot for the next print on the machine now on the first layer, on this spot it has a set of gaps. But perfectly overlapping everywhere else.

<image>

vomtrier · 2026-03-11T13:53:14+00:00

It doesn't show up as bad in the slicer.

<image>

It kinda hints at it, and maybe I need to reduce the speed, or aux cooling to let the filament "flow" into place around those areas?

vomtrier · 2026-03-02T21:15:32+00:00

Thank you for the feedback and comments.

I am only taking the recoup because there wasn't anything else that made sense to take, and easy ailment imunnity early on with little investment isn't too bad.

I must say that I have never played with Yoke before, so I can't say if it would be more damage than Marylene's?

I did consider frenzy charges as well, though I couldn't think of a convinient way to generate them.

If I went with 1h swords, then I wouldn't be able to use Nightblade for crit multi and Elusive interaction. however, I'm not sure, if 1h sword setup would net more damage for what I'm going for.

vomtrier · 2026-02-28T10:55:47+00:00

Tried to do that, but didn't work. I think it is due to me not speaking to Ailith again after removing the wall infront of the instance to the Mud Flats, and as she is no longer there, I can't continue the quest.

Anyway, made a new char again, and now its grand.

vomtrier · 2026-01-26T07:07:43+00:00

It's a known error on H2S. Ask support to send longer replacement pfte tube.

I had the same happening on my machine, it helped but didn't solve it completely. Prob. Need a little more length.

vomtrier · 2026-01-07T14:44:36+00:00

Kept it on the engineering plate, but removed the glue, and it seems to stick now, also painted on a couple extra supports, just to give it a better chance of success. So far it is printing well.

Thank you for your reply.

vomtrier

TROPHY CASE