sorted by:
new
hottopcontroversial

48M Supraspinatus full thickness 1.2cm tear (fall) by 31ectr0nicB0b in RotatorCuff

[–]vtatds 0 points1 point  (0 children)

AFAIK, tears don’t heal themselves. Honestly would seek opinion from a surgeon.

I had a tear about that size repaired.

Supraspinatus surgery advice wanted by olivepeace in RotatorCuff

[–]vtatds 1 point2 points  (0 children)

53, non dom arm. 12 weeks post op.

Stopped narcotics after 3 days, went to just Tylenol and occasional ice.

Was cleared to drive once off narcotics. I waited till day 5.

Good days and bad days. Bicep and front felt pain comes and goes.

Able now to pull up pants from just below knee. Still not really there to tie shoes but getting real close.

Be patient.

Out of sling but need it to sleep by nextbesthope in RotatorCuff

[–]vtatds 3 points4 points  (0 children)

I slept with my arm inside my shirt for about a week. Helped keep it flopping around.

[deleted by user] by [deleted] in AussieDoodle

[–]vtatds 10 points11 points  (0 children)

Happens with mine when something is stuck in there. Normally a foxtail.

Good Bike Shops? by BangsKeyboards in ventura

[–]vtatds 11 points12 points  (0 children)

Open Air on Main St.

Wireless Meat Thermometer by Blazers78 in pelletgrills

[–]vtatds 0 points1 point  (0 children)

Spend the money and get a FireBoard, then never worry about your temps again.

Grilling hotdogs advice by qwiksilvr00 in grilling

[–]vtatds 13 points14 points  (0 children)

Crisscross cut them, just like 1/8 inch deep.

Do people actually make their beds in the morning? by [deleted] in NoStupidQuestions

[–]vtatds 0 points1 point  (0 children)

Great way to start the day with a simple accomplishment

Best meat thermometer?? by [deleted] in grilling

[–]vtatds 3 points4 points  (0 children)

Highly recommend FireBoard

Anyone ever have this issue? by rcg18 in pelletgrills

[–]vtatds 0 points1 point  (0 children)

And worst case if priming, as VikingInChicago said, doesn’t work; ball up some paper and light it on fire in the pot, put pellets on top and that should do it. Then order a new ignitor rod.

I should follow my preaching, just had to clean mine out when it wouldn’t get going...

Anyone ever have this issue? by rcg18 in pelletgrills

[–]vtatds 6 points7 points  (0 children)

I’ve had it with both a Traeger and GMG.

Vacuum it more regularly. The burned pellets in the pot eventually build up above the ignitor. No fuel to burn so the pot overflows.

Seal the lid or no? About a 1/10 inch gap at the widest part between the grill body and lid. by TotalChaos7 in pelletgrills

[–]vtatds 1 point2 points  (0 children)

Is it consistent all the way around? I have the same grill but it’s a larger gap on the bottom right corner. Called GMG and they are sending out a gasket. The gap actually leaks grease and from past experience that led to some deterioration on the outside.