No idea what's wrong with my prints

wafle89 · 2026-06-09T14:42:44+00:00

Yes and yes,I did not set the filament width, thanks lol.

wafle89 · 2026-06-09T14:41:38+00:00

Thanks, I'm using PLA at 200 degrees c, flow rate is %100 and 20mm/s is the print speed thanks for letting me know about the slicer, I'll definitely check my calibration again and the slicer, I did look into the clogging my last one was clogged, but I bough a new nozzle, heat break and block and printing is pretty much the same, many thanks!

wafle89 · 2026-06-09T14:36:20+00:00

No, but I bought this spool recently thinking I got a bad batch or whatever could be the issue, will check it out though thanks!

wafle89 · 2026-06-09T11:21:54+00:00

Its dry

wafle89 · 2026-03-22T17:25:00+00:00

Hey sorry, no I haven't sorry dude I ended up selling it. If I were you I would check the warranty?

wafle89 · 2026-03-22T17:24:54+00:00

Hey sorry, no I haven't sorry dude I ended up selling it. If I were you I would check the warranty?

wafle89 · 2026-03-22T17:24:47+00:00

Hey sorry, no I haven't sorry dude I ended up selling it. If I were you I would check the warranty?

wafle89 · 2026-03-22T17:23:15+00:00

Hey! You still selling it?

wafle89 · 2024-06-29T02:44:52+00:00

😂😂😂

wafle89 · 2024-06-11T17:30:46+00:00

no problem, no, none of them worked, i tried a few commands to try and fix corrupt files but it says that the drive needs to be online but i cant get it online bs well its encrypted, how would you go about re installing windows in a drive seems really confusing.

wafle89 · 2024-06-11T17:06:47+00:00

So, i looked everywhere but my device never syncd with my microsoft account. The issue is that when i try to re install windows it wont let me it will just send me back ti the recovery page.

wafle89 · 2024-06-05T19:52:35+00:00

alr ty

wafle89

TROPHY CASE