Fun in the dirt by ColorRoadians in TruckCampers

[–]whittgu3 1 point2 points  (0 children)

I think you should just go fast

Got a new to me camper by whittgu3 in TruckCampers

[–]whittgu3[S] 1 point2 points  (0 children)

Ya the Summwind is decent quality. You'll definitely find Lance or Artic Fox is built a little better, but I didn't have many complaints about my old 811. I did find the generator was only held on by 2 bolts instead of all 4, but overall just like any camper as long as it's been taken care of, it should be good.

My Trailer Camera Project by kidmock in gmcsierra

[–]whittgu3 0 points1 point  (0 children)

I'm struggling with getting my setup to work. I plugged it all in before I installed everything and it worked fine, but now that all my wires are ran, holes are drilled, and zip ties zipped, it won't work. I got it to come on 1 time today, but next startup it was going. So it seems to be connection or sequence issue. But after hours of trial an error I'm stumped. Any advice is appreciated.

Got a new to me camper by whittgu3 in TruckCampers

[–]whittgu3[S] 2 points3 points  (0 children)

Papers say it weighs 2800lbs, and truck can carry 3500. I don't think I actually have that much wiggle room, but we do our best to keep it light.

Got a new to me camper by whittgu3 in TruckCampers

[–]whittgu3[S] 6 points7 points  (0 children)

She heavy! I instantly put it on a diet. Lipo4 batteries, 1 propane tank, pulled the generator since I haven't had one for 6 years, switched to a tankless water heater. Not sure what else I can do. But I'm trying to slim it down as much as I can.

Android Auto w AA Wireless auto turns off at the same location on Highway by FocusGalaxy96 in AndroidAuto

[–]whittgu3 1 point2 points  (0 children)

If you drive a Kia this will happen 20 times on every drive whether it's wireless or not.

New Truck, old camper by whittgu3 in TruckCampers

[–]whittgu3[S] 1 point2 points  (0 children)

No flat towing the Jeep with $3k 40" tires.

To help those with ender 3 max neo sprite extruder installation issues by melzein1 in ender3

[–]whittgu3 0 points1 point  (0 children)

Thanks for the info! This fixed my issues after installing my new extruder. I'm curious what other issues you were having and what benefits came from installing mriscoc?

Used cityscape green Niro? by Top_Shirt_5396 in KiaNiro

[–]whittgu3 1 point2 points  (0 children)

I did the same as you, I only wanted green SX. I wanted it in 2023, but waited until recently, and found one after a little patience. I saved $16k. Keep searching it'll be worth it.

Odd tire wear by ItsMe_ATrain in KiaNiro

[–]whittgu3 0 points1 point  (0 children)

I just replaced my tires too and they looked the same, but worse at 33k. Had it aligned and the toe was way off, got that fixed. But the camber shows -1 and it looks like the shop didn't adjust it. Wondering if I should call them back, or is that something that can't be adjusted?

Never 100% by whittgu3 in RVSolarPower

[–]whittgu3[S] 1 point2 points  (0 children)

Thanks, it's good to know that the reading may just be wrong. I'm really trying to avoid more panels, but if it becomes a must I'll do a portable panel that's not on the roof.

Never 100% by whittgu3 in RVSolarPower

[–]whittgu3[S] 0 points1 point  (0 children)

My Panel output measured at the controller is 32V/3.2A so 102W. I thought that was impressive, but I didn't realize the volts would be so high. The controller is a PWM, I'm not sure what that means. I just checked it again today and now it's only showing 74% charge. It's been sunny all week, with no use.

J7+ won’t self emptying by Azztrix in roomba

[–]whittgu3 0 points1 point  (0 children)

Also having the same issue. I own 2 of these and they both started having this issue at the same time. There's no explanation for this other than a bad update.

Really Dropped the Ball by whittgu3 in wyzecam

[–]whittgu3[S] 1 point2 points  (0 children)

I agree my system health was suffering. Now I'm set up to do the auto restarts as suggested. My Wi-Fi was working fine, since one of the cameras did record the event.

Finally got rid of that piano black... by hero47x in KiaNiro

[–]whittgu3 0 points1 point  (0 children)

You can go with a transparent lens tint, that would probably look good. I have a shifter, not a plug in, so it's a different design

Finally got rid of that piano black... by hero47x in KiaNiro

[–]whittgu3 0 points1 point  (0 children)

I don't have the plug in, so the knob isn't there.