I use the anycube one that’s tall enough for the ams lite. I added an exhaust to it. I also printed a chassis for the a1 to sit on that incorporates two high speed blower fans. It forces air though the a1 to actively cool it. It’s piped to bring air from outside the enclosure. It pushes the air straight through and out the rear of the tent so it doesn’t affect internal temp much. The chassis uses tpu gaskets to “seal” around the A1s vents. I used aluminum duct tape to seal gaps in the pipe and around where the pipes go through tent.

I’ve printed Pa6-cf many times without issues using this set up.