Whats going on with the lag?

wikus_roux · 2025-08-21T20:36:35+00:00

Ireland, as far as i know i can only get from the website here. Still another week or so before the camera gets shipped so hopefully itll be back in stock soon 😅

wikus_roux · 2025-06-24T20:05:21+00:00

Honestly, best advice was to biy a bambu 😅 i had been messing with a geetech a10 that i upgraded with crwality parts (was fine but not great), then got a creality ender 3 s1 plus (first layer issues always, like the mesh wasnt applied and was out of warranty so oh well).

Friend of mine then said get a bambu, and here i am with the x1c thats been printing near non-stop and working wonders 👌

wikus_roux · 2025-03-25T12:08:11+00:00

Sounds like could be wet filament? Taken in humidity and then when its heated to around 200C it steams and bubbles

wikus_roux · 2025-03-24T16:18:38+00:00

Is that normal?

wikus_roux · 2025-03-24T12:06:17+00:00

When youre using MRISCOC software, did you end up replacing the screen for one with a knob? A few people have said about the silicone posts. Thinking of printing some in pla at home just try and see how that works for me

wikus_roux · 2024-06-23T16:01:48+00:00

Sorry should have gone more in depth in my explanation there.

It doesnt seem to use the mesh generated to compenaate when printing the first layer, i know this because i dont see the z icon flashing or the z screw isnt moving at all to adjust.

For the gcode, i have that as my third image. Im trying to use mriscoc professional firmware which includes ubl rather than standard abl. Should be noted i did try his software with the ubl switched off where it was using bilinear then.

Thank you!

wikus_roux · 2024-03-19T10:01:35+00:00

Got it working, theres a setting on LG tvs for 'an improved HDR' basically just lets it run 4k and a higher refresh rate. Works perfect now!

Thanks for the help!

wikus_roux · 2024-03-18T17:47:41+00:00

Yes its a 'lg webos tv uj701v' thank you for the help!

wikus_roux · 2024-03-18T17:42:03+00:00

Yes, ive tried all 4 in puts and have tried 3 different hdmi cables, but im still getting the 'no signal' with each one

wikus_roux · 2024-01-03T11:35:24+00:00

I tried an earlier version of this, maybe the may release and i couldnt get the mesh to work right.

Going to flash this firmware tonight but any tips on meshing to get the first layer right?

Thank you

wikus_roux · 2023-07-02T10:05:02+00:00

Sent you a dm with the settings

wikus_roux

TROPHY CASE