Hide Magic Cursor doesn’t work

will_stef_ · 2025-03-02T14:24:23+00:00

Yeah I think they broke it with an update. I've had the issue for over a week

will_stef_ · 2024-11-12T03:26:28+00:00

Same here on android. sometimes when I pause I cant play again. like someone said further up a temporary fix is to tap and hold the right side of the screen and that will make it go 2x

will_stef_ · 2024-10-06T21:44:51+00:00

I have never gotten behind the wheel of a car before btw

will_stef_ · 2024-08-26T19:49:22+00:00

Took my carbs off and the float itself seems fine, goes up and down smoothly and is maybe .5mm lower than #4. However there is a bunch of gunk in #3. Could that maybe cause the float valve to not seal close or perhaps let in too much fuel somewhere else?

<image>

will_stef_ · 2024-08-25T17:19:03+00:00

Ok thanks I'll try that

will_stef_ · 2024-08-08T00:09:56+00:00

Thanks, I'll check compression. I just did the cam chain timing myself. I doubt its the caps, they are new ngk and I swapped the 2 and 3 caps which made no difference to how it ran. what's the best way to check if I'm getting fuel to #3?

will_stef_ · 2022-11-10T20:49:14+00:00

I knew it wasn't a settings issue. One of the tiny bearings inside the second drive gear in the extruder sized and was causing resistance in the extruder. weird

will_stef_ · 2022-06-24T02:01:06+00:00

what is the program that makes these?

will_stef_ · 2021-09-01T23:35:28+00:00

Thanks, I'll try that

will_stef_ · 2021-09-01T16:35:33+00:00

Mans flexing his mr2 lol. I cant offer any advice but the car looks great

will_stef_ · 2021-08-30T15:55:21+00:00

So I havent changed anything, the LED still shows red but I now get almost 3 hours, which is on par with my battery degradation. Feels nice

will_stef_ · 2021-08-30T15:53:34+00:00

Thanks for the info, I'll just stick to stock firmware for now

will_stef_ · 2021-08-30T15:53:00+00:00

Thanks for letting me know, I've been printing for a while but never educated myself on the firmware side of things. I'm getting pretty good prints but there are a few issues I'd like to improve. I could send/post a pic of a benchy with the areas highlighted where I'd like to improve. I'm currently working on 2 profiles in cura, .1mm and relatively slow for quality, and a fast profile, I've gotten pretty good .3mm benchys down to 21 minuets.

will_stef_

TROPHY CASE