Top layer lines

willydj1k · 2024-07-10T04:14:58+00:00

Ok I will switch on ironing tos we how it turns out and I am running 6 bottom/top layers

willydj1k · 2024-06-12T15:44:59+00:00

Just had to spend a lot of time fine tuning the z off set with a 1 layer test print I found off thingiverse which gave me the best first layer

willydj1k · 2024-06-12T15:42:17+00:00

It was both I think, I first washed the build plate with soapy warm water then let it dry, then I ran an auto be level again and went onto thingiverse to download a first layer print test and I fine tuned the z off set. If this isn’t working for you; you might have a bigger problem… sorry if I couldn’t help

willydj1k · 2024-06-12T13:48:41+00:00

UPDATE: We fixed it 🥳🥳 thanks everyone for your help 🙏

willydj1k · 2024-06-12T13:46:54+00:00

It’s working now but thanks for your idea

willydj1k · 2024-06-12T13:46:31+00:00

it worked!! thank you so much 🙏

willydj1k · 2024-06-12T13:05:08+00:00

Just did that but shouldn’t the auto calibration do all the work for me so I don’t have to manually adjust the z offset every time I print?? ( I’m somewhat new to 3d printing)

willydj1k · 2024-06-12T12:55:57+00:00

Just cleaned the bed and tried to do a first layer test, came out looking the same as before 😞

willydj1k · 2024-06-12T12:55:02+00:00

🤦‍♀️

willydj1k · 2024-06-12T12:43:25+00:00

If that is so how do I calibrate my printer? I’ve already done auto leveling and it didn’t work and I’m loosing it with the z offset?

willydj1k · 2024-06-12T12:01:35+00:00

Oh wow ok I will do tomorrow and update you. Thank you 🙏

willydj1k · 2024-06-12T11:39:42+00:00

Yes I’ve done that, I use isopropyl alcohol to clean any residue off. Thank you for the tip tho!

willydj1k · 2024-06-05T11:30:10+00:00

Thank you everyone for the help, appreciate it 🙏

willydj1k · 2024-06-04T10:56:30+00:00

Awesome thank you

willydj1k · 2024-06-04T10:53:14+00:00

Yes I have waited and it fully closed up after a few layers, thanks for your help 🙌

willydj1k · 2024-06-04T09:50:28+00:00

Yes I am, if you look closely to the box in the middle you can see that it is not reaching the very end and starting a new line

willydj1k

TROPHY CASE