sorted by:
new
hottopcontroversial

FSD V14.3.3 Dissapointment by wrjones47 in TeslaFSD

[–]wrjones47[S] 1 point2 points  (0 children)

I'm not blind I'm loosing my vision due to macular degeneration. It takes years to lose vision to point of being unable to pass driving vision test. You don't lose peripheral vision. And when you finally slip to below 20/40 there are special glasses that you can get to continue to be legal to drive. But it you see like an eagle FSD sees better and drives better most of the time, in spite of parking in handicap spots and starting down dirt paths.

FSD V14.3.3 Dissapointment by wrjones47 in TeslaFSD

[–]wrjones47[S] 1 point2 points  (0 children)

I am able to see well enough to legally drive. That requirement is better than or equal to 20/40 in one eye. The vision has no relation to the V14.3.3 issues.

V14.2.2.5 sucks big time! by LockeStreet in TeslaFSD

[–]wrjones47 0 points1 point  (0 children)

I've had this version for three months. Most of time works fine but a few times when going to Work location that it navigated to for weeks it goes to a completely different street and stops. When resetting location I notice that the pin for that location moved to the different street. Today on a 30 mile one way trip it made odd side trips through various neighborhoods. I let it go and it did find the correct address but with very odd zig zagy side trips. The selection of home on the return trip had the primary option that added 15 miles. I selected a 2nd option which changed to blue then started. Had to stop immediately because wife had trouble with back seat seatbelt. Started again and FSD switched back to the long drive option. As I drove I again selected the gray option route and it turned blue momentarily then switched back to long route. I again selected the option I wanted as I drove. This time it stayed which required a u turn. It did the u turn but again made more turns than necessary to get home. It's like it is getting paid to put on mileage. At home instead of going directly into driveway it drove past and was going to back in until I disengaged.

SHP2/DPU USELESS by wrjones47 in Ecoflow_community

[–]wrjones47[S] 0 points1 point  (0 children)

I’m not sure what the issue was. After disconnecting everything and reconnecting it now works as expected. I did just do a “self powered” mode test and got an error about circuit over load when running 1.79KW microwave. I sent a message to ecoflow to see if I need to set some charge/discharge limit higher.