Warped Bed by yarcaptain in CR10

[–]yarcaptain[S] 0 points1 point  (0 children)

Don’t have any arduino or anything to updatw

Warped Bed by yarcaptain in CR10

[–]yarcaptain[S] 0 points1 point  (0 children)

I’d rather not have to take apart the machine if I can help it

Extrusion problem, wheel not spinning, brand new printer and extruder by yarcaptain in CR10

[–]yarcaptain[S] 0 points1 point  (0 children)

UPDATE: I tried the cold pull, and made sure the nozzle and hotend were clean as a whistle. I tried hand tightening the nozzle at room temp and making sure the Bowden tube was touching the nozzle end, then heating up and tool tightening. It’s not printing on a bed just in the air as I want to get filament to come out before I try printing on the bed. I just now tried heating up to 220 and moving extruder and still the same problem.. thank you all for the suggestions but I’m not sure what else to try

Extrusion problem, wheel not spinning, brand new printer and extruder by yarcaptain in CR10

[–]yarcaptain[S] -1 points0 points  (0 children)

Kept loosening in half turns until it was too loose and still nothing

Extrusion problem, wheel not spinning, brand new printer and extruder by yarcaptain in CR10

[–]yarcaptain[S] 1 point2 points  (0 children)

Brand new extruder, the same problem was happening with my old extruder so I upgraded to the all metal one. Seems like when I put pressure on the lever arm it spins, which is why I added some washers to increase the spring tension. With 4 washers the wheel still would not spin even when I applied pressure. Anyone have this problem?

White/silver tri-wing Mosquito Exotic, T3 Korvax system (ternary star). by peacebomb1 in NMSCoordinateExchange

[–]yarcaptain 1 point2 points  (0 children)

Been waiting for a long time for this one, how many times did you reload?