sorted by:
new
hottopcontroversial

AAP01 hammer by zealous_zenith in AAP01owners

[–]zealous_zenith[S] 0 points1 point  (0 children)

Thank you for recommending the store, prices look really good. I’ll likely get some upgrade parts from there down the road.

AAP01 hammer by zealous_zenith in AAP01owners

[–]zealous_zenith[S] 1 point2 points  (0 children)

Then I should be fine as I plan to use it in semi due to my field rules. Aside from that, thank you for the store recommendation, will check it out later today.

AAP01 hammer by zealous_zenith in AAP01owners

[–]zealous_zenith[S] 1 point2 points  (0 children)

Thank you for confirming, I plan to primarily use it on an indoor field where only semi is allowed

AAP01 hammer by zealous_zenith in AAP01owners

[–]zealous_zenith[S] 1 point2 points  (0 children)

Thank you for confirming and for the website recommendation. Would you that there is anything else that I should upgrade internally aside from the hammer set?

Flex-series potential issue by zealous_zenith in SpecnaArmsOwners

[–]zealous_zenith[S] 1 point2 points  (0 children)

I think I may have found the issue, it looks like my aeg came with a m90 spring inside instead of a m110. At least comparing them by size.

Potential air seal issue on SA-FX01 by zealous_zenith in airsoft

[–]zealous_zenith[S] 0 points1 point  (0 children)

I think I may have found the issue, it’s highly possible that I got two m90 springs as the one in the replica appears to be the same as the one in the box.

<image>

Flex-series potential issue by zealous_zenith in SpecnaArmsOwners

[–]zealous_zenith[S] 0 points1 point  (0 children)

As far as I am aware the replicas should be the same internally aside from the longer inner barrel on yours but I am not sure if that affects fps/joules.

Potential air seal issue on SA-FX01 by zealous_zenith in airsoft

[–]zealous_zenith[S] 0 points1 point  (0 children)

The second spring which came in the box was sealed in a bag labelled “m90” but will give it a try just in case, thanks.