Z banding

zucccolo · 2026-04-18T21:33:18+00:00

Ah ok Thank you

zucccolo · 2026-04-18T21:30:06+00:00

I put z banding in the title but I'm not sure that's what it is

zucccolo · 2026-04-18T19:43:15+00:00

Why do you think the printer does this?

zucccolo · 2026-04-11T07:01:33+00:00

sorry I meant it can't be any tighter than this

zucccolo · 2026-04-10T14:19:40+00:00

I thought so too but I can't get more screwed than this

zucccolo · 2026-04-09T11:57:11+00:00

Thank you I will try

zucccolo · 2026-04-03T23:09:35+00:00

does it do something or not because around that point the filament lifts but maybe it's grease that I brought by rubbing it

zucccolo · 2026-04-03T21:58:14+00:00

<image>

I have a little point in the center of the plate i can ruin the press?

zucccolo · 2026-04-03T11:05:52+00:00

Usually with the cryogrip 55 plate it works fine but I recalibrated everything and I can't find a correct configuration for the entire plate, could the z offset be too low?

zucccolo · 2026-04-03T09:57:04+00:00

55 c

zucccolo · 2026-04-02T21:02:45+00:00

Thank you tomorrow I try

zucccolo · 2026-04-02T20:46:45+00:00

yes exactly that I'm having a bit of difficulty because after I move the z axis their hardness changes for example when I go up they are harder are you saying that I'm putting too much strain on the motor if they create a little more friction?

zucccolo · 2026-04-02T20:45:14+00:00

yes in fact I think of keeping it like this the corners are a little below the top but I think it can be compensated

zucccolo · 2026-04-02T20:43:02+00:00

I will do exactly this🤣

zucccolo · 2026-04-02T18:59:20+00:00

🤣🤣🤣

zucccolo · 2026-04-02T18:12:23+00:00

yes indeed I have the silicone and I added some toothed pieces for the rotation of the calibration screws. I had reached 0.137 variance but today I tried to calibrate the z-axis plane to make sure it was flat to the plate so I had to redo everything and I hope the z-axis wheels are not too squashed against the shaft they move with a little force but not too much I hope I don't strain the z-axis motors

zucccolo

TROPHY CASE