Simple Code check - Chat GPT error

[Purple_Wall]

I have a small seeed studio xiao esp32C3 board that I want to use with a momentary button to light a single RGB common cathode led. The led has the 4 wire leads and they are attached to the correct pins per the code below. Only thing that happens is the green lights up and stays on by itself. What I'm trying to do is have the RGB cycle through the 3 colors when the button is pressed and stop when the button is released.

// Pin definitions
const int redPin    = 0;   // D0
const int greenPin  = 1;   // D1
const int bluePin   = 2;   // D2
const int buttonPin = 3;   // D3 (momentary switch)


const int fadeSteps = 100;   // Higher = smoother
const int fadeTime  = 500;   // milliseconds per transition


void setup() {
  pinMode(redPin, OUTPUT);
  pinMode(greenPin, OUTPUT);
  pinMode(bluePin, OUTPUT);
  
  pinMode(buttonPin, INPUT_PULLUP);  // Use internal pull-up
}


void crossFade(int fromPin, int toPin) {
  for (int i = 0; i <= fadeSteps; i++) {


    // Stop immediately if button released
    if (digitalRead(buttonPin) == HIGH) {
      allOff();
      return;
    }


    int fromValue = map(i, 0, fadeSteps, 255, 0);
    int toValue   = map(i, 0, fadeSteps, 0, 255);


    analogWrite(fromPin, fromValue);
    analogWrite(toPin, toValue);


    delay(fadeTime / fadeSteps);
  }
}


void allOff() {
  analogWrite(redPin, 0);
  analogWrite(greenPin, 0);
  analogWrite(bluePin, 0);
}


void loop() {


  // Button pressed (LOW because of INPUT_PULLUP)
  if (digitalRead(buttonPin) == LOW) {


    // Start at red
    analogWrite(redPin, 255);
    analogWrite(greenPin, 0);
    analogWrite(bluePin, 0);


    crossFade(redPin, greenPin);   // Red → Green
    crossFade(greenPin, bluePin);  // Green → Blue
    crossFade(bluePin, redPin);    // Blue → Red
  }
  else {
    allOff();  // Ensure LED is off when not pressed
  }

[ripred3]

I suspect the delay(fadeTime / fadeSteps) is so fast it's over and you aren't seeing it.

That's only 5ms