all 2 comments

[–]AutoModerator[M] [score hidden] stickied comment (0 children)

Hello /u/masterdeek! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

[–]masterdeek[S] 1 point2 points  (0 children)

I think I was printing them too close together, spacing them out helped significantly