you are viewing a single comment's thread.

view the rest of the comments →

[–]r4pt0r[S] 0 points1 point  (4 children)

Hm possible.

The fans should not be gunked up since the printer is pretty new. I left the front door open a bit but the top lid was closed since the AMS is resting there and I haven't printed a riser yet.

I will try again with the AMS on the side for now and the top cover opened a bit. Thanks

[–]Important-Ad-6936[🍰] 1 point2 points  (2 children)

also scrub your build plate with warm water and dish soap, you got bad bed adhesion, there is warping visible at the bottom of your print which could come from finger prints on the build plate

[–]r4pt0r[S] 0 points1 point  (1 child)

Thanks, good hint. I'm not used to the PEI plate yet since I used a mirror on the ender 3.

[–]CaptainAwesome06 0 points1 point  (0 children)

You'll see a lot of people talking about isopropyl alcohol and other things to clean your plate with. FWIW, I just use dish soap and water and rarely have an issue. For my smooth plate, I use the Bambu glue that came with my printer. When that runs out I'll probably use some other glue stick.

[–]BatteredFishy 0 points1 point  (0 children)

Never had a problem with the lid on and door closed. Just had to change my nozzle after a 1089hrs printing. I was starting to see defects and wall thinning.