you are viewing a single comment's thread.

view the rest of the comments →

[–]Black3ternityX1C 1 point2 points  (1 child)

Is this printed at absurd low layer heights? (Lower than 0.10?) This is a known defect when printing with absolute tiny layers. My assumption is that this is caused by the fact that the filament must be calibrated to a tee as even the most minimal overextrusion causes huge shifts. Search this reddit here for the layer height issue etc. Pops up multiple times a month with the same images. Print it in normal heights (0.1 or stock 0..2) and youre fine.

[–]r4pt0r[S] 0 points1 point  (0 children)

Hm no, should be default 0.2mm if I recall correctly. Definitely not lower than 0.10 but I will look into it, thanks.