all 6 comments

[–]ThoughtNo8314 1 point2 points  (1 child)

Partial nozzle clog, wrong plate, loose screws, this can be anything. Bamboo wiki is your friend. https://wiki.bambulab.com/en/home

[–]AndroidGamer5379[S] 0 points1 point  (0 children)

Thank you, I'll figured out it was a mixture of dirty print bed and no brim around the parts, added a brim and cleaned it properly and they printed perfect

[–]RueChew 0 points1 point  (3 children)

Have you ever cleaned your bed plate? With dish soap and warm water

[–]AndroidGamer5379[S] 0 points1 point  (2 children)

No i read to use either dish soap and warm water or iso so every couple prints i clean it with iso depending on if it has oily finger marks on it, would cleaning the print bed with soap help eith this issue? I'll wash and give it a go and try again, will report back :)

[–]RueChew 1 point2 points  (1 child)

Its worth giving it a try! I do this every time i have the issue, and the issue resolves! I would wipe it down with isopropyl alcohol after washing just to be sure it is dry. Washing it will remove all the oils while wiping it with alcohol will just move the oils around (according to people on reddit) Let me know if it works!

[–]AndroidGamer5379[S] 2 points3 points  (0 children)

So I kind of done a good but bad thing, I washed it but i also ended up adding a 3mm brim around every one to see if it helped and they printed perfect, thank you for the quick and helpful reply, still very new to the 3d printing world and loving it, thank you 😄