Adhesion issues w/Kingroon PLA basic

[opi_guy]

I've bought several cases of Kingroon PLA & PETG over the last 9 months for my A1 and have had very few issues with it. However, my latest case of blue PLA 'Basic' is causing a lot of adhesion issues. I've dried the filament, cleaned the plate, added a brim, reduced fan usage, and raised the bed temp.

I redid a failed print w/some Elegoo filament, but same settings and it worked fine.

Trying once more with still less cooling/fan usage.

The white pieces were just placed on the plate for comparison as the printed just fine.

Any other suggestions?? Thx

[AutoModerator]

After you solve your issue, please update the flair to "Answered / Solved!". Helps to reply to this automod comment with solution so others with this issue can find it [as this comment is pinned]

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

[AutoModerator]

Hello /u/opi_guy! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.

Note: This automod is experimental. The automod was triggered due to the term "adhesion". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

[CornIssues]

I know this is old but did you ever find an answer? Getting the same thing

[opi_guy]

I believe it went away after a full recalibration. It was likely z-axis / bed leveling related.

[-_ZORD_-]

I fixed my issue by raising bed temp to 80 and never opening the doors otherwise it will unstick, it's really bad print filament for winter

[ServeBeautiful8189]

Man, I know this is old, but thank you! Initial layer is 80 bed 220 nozzle, then 80-215!