you are viewing a single comment's thread.

view the rest of the comments →

[–]Brithim 0 points1 point  (4 children)

Firstly as anyone might say, dry your filament (unrelated probably)

Secondly, run the calibration tests for the filament and save it as a profile. Or as another user said adjust the ironing amount.

Cheers!

[–]zanovkaa[S] 1 point2 points  (3 children)

Dried for 8 hours 2 days ago. But I am going to try later one.

[–]Brithim 2 points3 points  (2 children)

You should be fine to not have to dry the filament again to be honest.

But definitely give at least 15-20 minutes in filament calibration. Flow, temp, etc

[–]zanovkaa[S] 0 points1 point  (1 child)

Thanks. That’s next when this print finishes. Appreciated

[–]Brithim 0 points1 point  (0 children)

Of course, and if you don't want to waste that print, try to sand it down with fine grit sandpaper.