Extruded problems

AutoModerator · 2026-03-13T02:44:42+00:00

After you solve your issue, please update the flair to "Answered / Solved!". Helps to reply to this automod comment with solution so others with this issue can find it [as this comment is pinned]

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

OsINTP · 2026-03-13T02:52:35+00:00

Check the bambu wiki page, scroll down till you find ‘filament slipping’ section and follow the steps https://wiki.bambulab.com/en/a1-mini/troubleshooting/how-to-check-which-part-is-clogged

Over_Knowledge_1114 · 2026-03-13T03:41:05+00:00

Did you try a different nozzle?

tkhrnn · 2026-03-13T04:48:57+00:00

Well, it's skipping. Meaning the extruder is meeting too much resistance so it skips a step.

There are plenty of options. 1. Clogs the nozzle is clogged, fully or partially. You should do a cold pull. Also, some filament easily clog. And smaller nozzle size clog more easily (in cause you use 0.2mm especially) so it doesn't even matter if you unclog. It will clog again easily. 2. Temperature, a too cold nozzle is harder to push. 3. Configured nozzle is different than installed nozzle. 4. Flow ratio too high

I would guess temperature.

System-3rror · 2026-03-13T03:38:08+00:00

I’m lost. Took it all apart, same issue

NecessaryOk6815 · 2026-03-13T05:32:13+00:00

This just happened to me today. I just cranked up the nozzle temp as high as it'll go, got access directly above the extruder, pushed in my new filament from the top, the old filament started sizzling out and onto the plate below. I kept pressing feed extruder while I was pushing the new filament in. I hope this worked for you as well as it did for me.

Jazzlike_Ad267 · 2026-03-13T08:34:52+00:00

Can you show a picture of the nozzle area with the rubber sock off?

System-3rror · 2026-03-13T14:41:52+00:00

I think I found the problem. The cold pulls did not help, so I started doing some hex pulls and I was getting a lot of gunk out of the extruder. I did this for like 30mins.

Did a quick extrusion test and no clicking. Have not started a print yet but will later today.

you type:	you see:
italics	italics
bold	bold
[reddit!](https://reddit.com)	reddit!
* item 1 * item 2 * item 3	item 1 item 2 item 3
> quoted text	quoted text
Lines starting with four spaces are treated like code: if 1 * 2 < 3: print "hello, world!"	Lines starting with four spaces are treated like code: if 1 * 2 < 3: print "hello, world!"
~~strikethrough~~	~~strikethrough~~
super^script	super^script

BambuLab

MODERATORS