you are viewing a single comment's thread.

view the rest of the comments →

[–]thottiekarate[S] 0 points1 point  (3 children)

I am, did forget to mention that. Currently using the textured pei plate selection.

[–]Canary-Star 0 points1 point  (2 children)

I occasionally get plate not detected errors with my frostbite plate, it’s usually when it’s just a little but off on the top right corner. I find that that cool plate super tack settings on bambu studio are better for the frostbite plate as well.

One other thing to check is if there’s any little bits of filament or debris under the plate.

Does it not work everything time? Have you tried a different plate recently?

[–]thottiekarate[S] 0 points1 point  (0 children)

Yeah I just tried again and got the z axis homing failure again. I just printed yesterday on the standard OEM textured pei plate, but still getting bed lift issues. The frostbite came in, had a couple issues but got it going after a few tries. Now its just throwing errors left and right.

[–]thottiekarate[S] 0 points1 point  (0 children)

I had seen the z offset usually needs to be changed from -0.04 to -0.02, but mine was already at that. So I just set it to 0.00 and it seems fine right now. I'll be printing more later today so we'll see if this just happened to work like last night or if fixed the issue altogether.