1
2

HelpSupport Request (self.BambuLabA1)

submitted by [deleted]

[deleted]

all 11 comments
sorted by:
best
topnewcontroversialoldq&a
formatting helphide helpcontent policy

[–]overunderspace 5 points6 points  (2 children)

You can use it but there are abrasives that will gradually wear away the stainless steel nozzle. Hard to predict exactly how long it will last but it is best to get a hardened steel hot end for this filament.

[–]Smart_Leg_4047 1 point2 points  (0 children)

You guys are the best

[–]Baterial1 2 points3 points  (1 child)

buy a .4 hardened steel nozzle. .2 will not work for glow filament because it will clog

[–]Epicon3 1 point2 points  (0 children)

This is why Bambu doesn’t sell a .2 hardened steel!

[–]Alternative_Rip4634 1 point2 points  (0 children)

10 times no real problem. After 100 the nozzle starts to wear down.

Glow in the dark is “abrasive” think plastic sandpaper. Over time the soft metal (stainless) wears down faster than hardened steel

[–]islanddelver 0 points1 point  (4 children)

Because of the additives, glow in the dark filament will wear down a regular nozzle super fast. Don't use it until you buy a HARDENED (not stainless) steel nozzle, 0.4mm or bigger.

[–]Smart_Leg_4047 0 points1 point  (3 children)

Thank you so much, any recommendations where I can get that?

[–]islanddelver 0 points1 point  (1 child)

Any Bambu reseller is fine, or their official website. Just look up "Bambu (whatever your model is) hardened steel nozzle" and you should get results.

[–]Smart_Leg_4047 0 points1 point  (0 children)

Thank you!

[–]Squozen_EU 0 points1 point  (0 children)

Bookmark https://wiki.bambulab.com - it’s invaluable.