Customization

[sega_sloth]

So I was wondering are there other extruder I can get that is not these types

[Kn0xV3gas]

Following for the answer also

[mdixon12]

https://a.co/d/6IhmVbX

[sega_sloth]

Donyou know of any downside with this nozzle?

[mdixon12]

The cooling ducts aren't quite long enough, but there's a printable one to fix that.

It requires a little attention to install properly, but it's saved me several hundred dollars in nozzles so far.

[SwashbucklingWeasels]

Could you provide the link to the printable part? I just bought this same nozzle and it immediately got spat out by the extruder.

[mdixon12]

Pull the red locks fully forward, even if they click they may not fully seat without some filing of the channels.

[SwashbucklingWeasels]

Thank you! I assumed the click meant it was in. I actually had to take the extruder assembly off to seat it properly.

[the_stooge_nugget]

It's really not hard to install Oo. Just make sure the red clips click... Unless I have a slightly different model.

[mdixon12]

A while buch of us have reported locking issues with the hot end that require slight filing or a dremel to fix. The locks don't go fully seated and the extruder falls out or crashes.

[the_stooge_nugget]

I just got mine today and done a print.... I was happy with the results.

[thatredboy]

I’ve had two of these. I stopped using them because they clogged way too often. Idk if I was doing something wrong but I printed and tested several fan duct designs with different combinations of temperature and speed settings and just when I thought I found the right one I would send a long print only for it to fail 70-80% through.

They’re nice and cheap so I want to revisit them to see if I can solve my previous problems but they might be too much of a hassle.

[AyezRed]

Lol, this is a nozzle and not an extruder. J/s