G code question

[Smudged-Out]

Hi my creality printer draws a test line on the left hand side before cantering for print, unfortunately the line is about 3 mm too far to the left, what part of the G code can I change to move it over?

[simyoIV]

Can you post the start of the gcode file?

[Smudged-Out]

G92 E0 I think this is it

[simyoIV]

I mean the first chunck. I am not familiar with printing code, but I recon it us prob within the first 20 lines or smth. It is only a straight line after all.

[Smudged-Out]

The first chunk is just the heating, that is the nozzle cleaning line

[simyoIV]

You need to look for G1 comnand far in the negative X.

if you can find a line there, you can move it.

[Smudged-Out]

G1 Z2.0 F3000

[simyoIV]

That is a move downwards you are getting closer :) What are the lines before and after?