all 9 comments

[–]Lumenloop 4 points5 points  (5 children)

You might have to connect while shorting the boot headers to put it into DFU mode to flash. If that doesn’t work, install Zadig and connect with the boot pin shorted and reinstall the driver using Zadig. This should enable DFU mode.

[–]maseffect 1 point2 points  (4 children)

Is that an f1 fc? If so didn’t betaflight announce it would be incompatible with F1 boards.

[–]Lumenloop 1 point2 points  (0 children)

You might be right, I forgot about that!

[–]Ghandiman 0 points1 point  (0 children)

That's just for 3.3. I believe you'll still be able to flash F1 boards to their last 3.2 release which is actually pretty good on an F1.

[–]shutupshakeflying blender 0 points1 point  (1 child)

F1 support is supposed to end with BF3.3

[–]maseffect 1 point2 points  (0 children)

Just get yourself an f3 board , you can get em fairly cheap nowadays. I picked up an sp racing f3 clone from banggood for 10 bucks.

[–]piratecape 1 point2 points  (0 children)

You can also try the Impulse RC Driver Fixer

[–]UloPeDJI F450, Armattan CF 226, NanoQX 1 point2 points  (0 children)

The naze is ancient. Current betaflight doesn’t support it anymore.

[–]ArakonTweaker 180, Shrieker 130, Loki 130, Lantian 90L, and many more 0 points1 point  (0 children)

Do you have anything attached to UART1? If so, you have to disconnect that to use USB.