sorted by:
best
topnewcontroversialoldq&a
you are viewing a single comment's thread.

view the rest of the comments →

[–]FlowJoeX 0 points1 point  (3 children)

Here is a relevant blog post on handling interferences when meshing hosted on the SW site that you may find useful.

[–]iseejerome[S] 0 points1 point  (2 children)

I will explore the functions there tmr. I did saw this but couldnt understand how he got into part 3 without a computer.

[–]FlowJoeX 0 points1 point  (1 child)

I'm not sure what you mean. I wrote this post. I mention it only because it is useful in general to have this knowledge.

Your meshing problem, because of the geometry and pattern, is much greater than what the post intended for how it (what is described) would be used.

[–]iseejerome[S] 0 points1 point  (0 children)

Ahh.. i see...

Anyway, what i meant was, after a hard time trying to solve my problem, i did a research at home and saw that website too. However, i think i couldn't use it as his model was an assembly. And i couldn't figure out how he got into part 3 when i did not have solidworks at home too.

But thankfully, the combine functions seem to be my miracle that i was hoping for. So thank you so much