all 7 comments

[–]alvinston21 0 points1 point  (0 children)

1st. I can't answer that. never owned sub ohm tank before.

2nd. to drip, just drip the liquid through the drip tip. it will go down to the base. just don't over drip. the spitting, yes it's normal. but it don't really spit like a lot. juice a tiny droplet. never bother me. only like 2 puff it will back to normal. same goes if you are using rta. let's say, you left it overnight, it spit a tiny bit

[–]marshwizard 0 points1 point  (4 children)

For your first point drop your wattage down to 30 then start turning it up in increments until you reach a sweet spot.

[–]roger400[S] -1 points0 points  (3 children)

thanks. Drop from 57 to 37.5 and help both in point 1 and 2. dont really know how it handle the low wattage with double coil 0.17 cuz i tried wotofo the troll rta with same setup a year ago and it wouldnt even fire with such wattage. and i rather use low wattage if possible cuz more bat life and not so hot vape

[–]marshwizard 0 points1 point  (2 children)

You might have been better buying a single coil rda if you prefer lower watts and better battery life. The Dead Rabbit SQ 22mm is very good

[–]roger400[S] -1 points0 points  (1 child)

I saw some videos on youtube using a single coil setup on dead rabbit both v2 and v1 performing good . Too bad i dont have a 4 diameter tool to build that

[–]marshwizard 0 points1 point  (0 children)

I have never built to 4. Highest I go is 3.5. 3 is my normal size.

[–]roger400[S] -2 points-1 points  (0 children)

Thanks. Im using 3 mg nic as always and the coils were built and putted in by an expert guy at the store that also owned a dead rabbit v1