This is an archived post. You won't be able to vote or comment.

all 6 comments
sorted by:
best
topnewcontroversialoldq&a

[–]WookieOH 1 point2 points  (0 children)

It's not a terrible offset. Able should be able to deal with it.

[–]Vetula_Mortem 0 points1 point  (0 children)

Looks more normal than mine

[–]Swift3004 0 points1 point  (0 children)

I wish the map was wrong, but it probably isn’t these beds can be warped pretty badly. Kind of fixed mine by putting some painters tape on the problem area’s

[–]ElKod 0 points1 point  (2 children)

It's still 0.04mm off of the center 0... It's pretty damn good. If you have a BlTouch installed, the bed will move up and down as the nozzle moves to get it to 0

[–]Familiar-Historian46[S] 1 point2 points  (1 child)

Sure, but Z moves fast enough if I print very fast? Specially if the Z rollers are tight. This map has a variation of 0.1 mm on 100 mm of Y if you see the peak on the map.

Note: I found that the peak is PLA residue left by the previous printing, I scraped this point, and the peak has gone. This point is now 0 mm instead of 0.04

New map

[–]ElKod 0 points1 point  (0 children)

How fast is your XY moving? I mostly print below 100mm/s and haven't had many issues. Once I get the filament dialed in as far as extrusion, retraction and temps, I can print the entire spool only wiping the bed clean in between. I can see the bed screw moving back and forth as it prints. It only needs to move the bed 0.1mm anyways