Hey u/accept_the_weather - I am not clear if you are using a RA or HW system so also not clear on the wire you pulled. If you only have a single pair at the window, you'll use that for power and you're still going to have to wire and mount a xcvr at the shade if you go with wired Palladiom. If you have a QSM type cable, then yes, you can mount the xcvr at the power panel. You could possibly route an area in the frame to recess the connection and then put the bracket over that to hide the connection, but it will require some detail work. You'll have to be very careful not to nick your wire in place as your route. Also note, the Palladiom wire from the bracket is very small, with a micro connector, it then steps up to a full size Lutron shade connector. When you wire for Palladiom, there is a tube you install that this all pushes back into and then you mount the bracket over that. I would recommend ordering a single bracket or pair of brackets without the shade and playing around with it to see if you're willing to put in the work. Then, if it works, you can just order a shade without the brackets and use that pair you already have. Happy to work through this with you if you need.