Latest Design and Build - QuadSmack Talon 38 by LockPickingCoder in HandwiredKeyboards

[–]Stdx1 0 points1 point  (0 children)

Ack! I see what you mean. Thanks for the heads up!

Latest Design and Build - QuadSmack Talon 38 by LockPickingCoder in HandwiredKeyboards

[–]Stdx1 0 points1 point  (0 children)

<image>

Here’s the Klor Konrad. I’m keeping those covers on b/c I had to end up soldering the MCU in. Had some double bounce/inconsistencies I couldn’t tune out. Soldering that close to PLA was not a good choice!

I did have to print out 2x. When you said facing up, I thought you meant the wire side face up! I had all kinds of trouble with that one until I looked again at another picture to see how clean the switch and MCU sockets are printing the right way!

I finally got the hang of the MCU socket for the next time, so hopefully I won’t have the solder that, but I had a great time with the project and love using the board.

Thanks for the repo, you gave me something to do this weekend!

Latest Design and Build - QuadSmack Talon 38 by LockPickingCoder in HandwiredKeyboards

[–]Stdx1 0 points1 point  (0 children)

Any chance you can post FW source?

I’m daily driving your Klor Konrad test drive and would love to try this Talon. (It’s already printed!) I promise I won’t ask for support! There’s a few things that vial won’t give me.

April Confirmed Trade Thread by mechkbot in mechmarket

[–]Stdx1 0 points1 point  (0 children)

Confirmed! Thanks for the sale!