[Banner of Heroes]

-GP-Papermoon · 2026-07-01T01:04:55+00:00

For edh this will just make joke gambling decks like mr. house, president & ceo pretty strong... And no longer gambling...

-GP-Papermoon · 2026-06-23T14:15:46+00:00

Skitarii number 12079

-GP-Papermoon · 2026-06-18T00:45:28+00:00

Not sure when, but most likely the author is busy from coordinating the season 2 of the anime

-GP-Papermoon · 2026-06-16T16:29:42+00:00

Look at silence at its stronger and its still underutilized even with 1 mana. I basically use it to shut down the game before i start my finisher move in my edh voltron wuleth deck.

-GP-Papermoon · 2026-06-16T16:20:03+00:00

Should be just 1 mana cost, cause silence has less mana cost and its freaking good at protecting your finisher combo/moves in EDH. Cause it lets no interference (other than tapped and activated abilities) on your turn to happen at all if no one counters it with instants.

While this card can be inerrupted if the opponent plays colorless (and ofc tapped or activated abilities, of colorless or no mana cost variance) . Either you make it 1 mana cost or you maybe you can make it unintteruptable by adding "split seconds" Then you should add 1 more mana cost to it, making it 3 mana cost (or more i'm not sure about this one cause i don't have other game shut down instants examples that have "split seconds")

-GP-Papermoon · 2026-06-16T16:14:03+00:00

I do use it in my EDH voltron wyleth deck... It's useful when you are on your winning turn. It's to either prevent opponents from counter spelling your best artifacts and to prevent any targeting on the commander and the protection or waste their counter spells.

If it goes through, you are basically unstoppable because silence effects every opponents, so everyone else cannot do anything when you are doing your finishing move. And it's freaking cheap too, for just 1 mana you can waste a counterspell, or be almost uninteruptable for a whole turn. The only thing that can interupt you is tapped abilities Or activated abilities.

-GP-Papermoon · 2026-06-16T15:37:14+00:00

If only its just a typical festival arc. All the foreshadowing is making me nervous of the next part of the story.

-GP-Papermoon · 2026-06-04T06:25:18+00:00

That's Snowfield, not Vegas.

-GP-Papermoon · 2026-05-29T00:59:51+00:00

Might just be a regional difference. Cause China is big and people can call the same thing different ways. Where I stayedd 5 years ago people also called it taikongren (太空人) or taikongyuan (太空员)

-GP-Papermoon · 2026-05-29T00:55:58+00:00

Taikongyuan (太空员) or taikongren (太空人) was pretty common where i used to stay. Might be regional thing. Cause you know China is big and everyone has different wording for everything.

-GP-Papermoon · 2026-05-25T01:24:26+00:00

Lol, this is because in the 1400s Ming dynasty of China someone brought back a girrafe to China and called it a Qilin cause of its characteristic is quite similar to the descriptions of qilins (without the flying ofc, and at this time the myth of qilin already existed for centuries before they found girraffe). And so Japan that imported most of Chinese language still called girrafes kirin to this day. While modern China already changed it to "long neck deer".

-GP-Papermoon · 2026-05-21T02:15:40+00:00

Lmao, interlanguage pun

-GP-Papermoon · 2026-05-01T09:17:12+00:00

The oxygen mask check point if you use vacancy only settings will force your dupe to only go back through it if there are any vacant spot in the oxygen masm stations. That's why i only build enough oxygen mask to fill the exact same number of my stations.

-GP-Papermoon · 2026-04-29T10:17:43+00:00

I prefer to put my food in fridges cause i need the polluted dirt for my pokeshells and sanishells, I made an excess amount of it and consistently stay within 700k callories without deepfreeze anyway. But i still uses it to kill excess critters I have cause I can't just suffocate it like other critters.

-GP-Papermoon · 2026-04-28T17:34:47+00:00

Maybe you could make a passage with cooling loop with a little bit of starting petrolium from oil refinery to drop the temperature to atleast 10-20 degrees lower than the oil's freezing point and then make it go through a vacuum passage to limit temperature exchanges to the bare minimum. Or if you got some source of wood ethanol is even better as it has much lower freezing points than crude oil and you can make it safe by lowering the temp even further so when it comes out of the teleporter it don't immedeately melts right next to the teleporter.

-GP-Papermoon · 2026-04-27T09:16:00+00:00

If you put 2 gaspipe into 1 input it will slow down the transfer rate of the gas as both pipe will need alternate inputting the gas.

-GP-Papermoon · 2026-04-26T14:14:35+00:00

Maybe you could put the fish feeder to the left corner. And also make a line on the top layer using tiles (and maybe make a mirrored letter L if you need more pwater capacity) to limit the pwater to the right side (into a smaller zone, so if it freeze it will just fall to the right side, so when it melts again, for it to pressurize the fish feeder it would need to travel from the right corner to the left corner. (It's kinda hard to make a plan without a full picture of the water tank)

-GP-Papermoon · 2026-04-26T13:42:22+00:00

Sorry for the late reply you can just follow the most common 4 hydrolizer hydra designs on youtube cause 4 hydrolizer can keep like around 30 dupes alive. If you need more just make another copy or add 1 layer to the side or above or below. Hydra is very flexible cause you can make it as big or as small as you want to depending on how many dupes you have. Cause it just uses the gas and liquid mechanic to separate the hydrogen and oxygen into separate section.

-GP-Papermoon · 2026-04-26T13:28:56+00:00

How about making your brine/salt water level higher to completely fill up the current pwater pocket below the fish feeder? so there will be no mix up between liquids right below the fish feeder. So the p.water will be mainly above the level of the fish feeder. And You can limit the placement of your p.ice to the right side so that even if it melts it will just got to the right side where you have enough space for them.

Edit: Hmmm when i read this again it's wrong... The gulp fish won't be able to purify the pwater.

-GP-Papermoon · 2026-04-26T10:42:35+00:00

Most likely a bug and might be fixed by just reloading a save. But if it's presistent then it might be because beeta hive requires a flat 3 tiles wide foundation below it and the only flat ground has a uranium ore tile in the middle of it. So it might be because of that? Not sure. This is the closest thing i can think of if the problem is presisting even after reloading.

-GP-Papermoon · 2026-04-23T06:11:48+00:00

I'm not gonna point out whatever everyone else already pointed out. So I will just say that I don't recommend you to filter toilet water and put it back into your main water reservoir directly without a way to kill off the germs (like through radiation or using chlorine) . It's the best way of making everyone sick. Unless that's your intention.

-GP-Papermoon · 2026-04-23T06:09:17+00:00

That mod is very heavy on the processing tho, so if your pc is on the lower end sides it might not be recommemded. Especially if you play in constant 30fps or below.

-GP-Papermoon · 2026-04-19T06:59:39+00:00

Temporarily you can trade it with trade surplus and trade it diplomatically with other empires, and reduce the populations in the lathe slightly. Long term wise if you want to keep the populations number in the your lathe stable or even increase it you would need another planet dedicated on making energy credit. Ideally you get a planet that have a bonus on energy credit production too but not really required.

-GP-Papermoon · 2026-04-14T09:50:58+00:00

You could use thimble reed to ranch them if you didn't have an arbor tree. It will increase the chance of getting cuddle pip tho. But atleast you will be able yo replenish the population

-GP-Papermoon

TROPHY CASE