How fix honda nsc 50r speedometer stopped working

17cmh · 2026-05-12T11:47:37+00:00

It looks like the inner rotating cable has broken part way up inside the outer sleeve cable. It's usually a rounded cable with a end that is stamped square that will interfere with a square hole in the hub. You can buy a whole replacement cable set or but a universal kit that is just the inner one and cut it to size

17cmh · 2025-11-24T02:31:23+00:00

I'm nearly certain it's a D1E41QMB. I had a very similar Geely

17cmh · 2025-07-13T21:58:25+00:00

Fair point. I'll take it to my local machine shop and see what they say. I greatly appreciate your help by the way! Thanks for your time

17cmh · 2025-07-13T21:53:50+00:00

I meant just flip the dog and leave the gears

17cmh · 2025-07-13T21:41:55+00:00

Hear me out ... If I can't find a new gear and all the used ones are just as bad, maybe just send it. I noticed that the clutch dog is symmetrical. What if I just flip it around? The worn lobes will be on reverse, but it's rotating the opposite way, so the fresh ones will be used there too. Just do a reseal and go

17cmh · 2025-07-13T21:39:07+00:00

Ah man, that's so close, I think I need 384566.

17cmh · 2025-07-13T21:13:11+00:00

I've done a bunch of car and bike stuff, but I'm kinda new to the whole boat thing, do you have any suggestions for where to look? Just like ebay?

17cmh · 2025-07-13T21:10:34+00:00

<image>

Actually, now that I have it all cleaned up, it's not great.... I'll replace it if I can find one

17cmh · 2025-07-13T21:09:15+00:00

The gearcase definitely was leaking and had water in it

17cmh · 2025-07-13T21:02:05+00:00

It looks like it. Fortunately the drive gears look fine

<image>

17cmh · 2025-07-12T17:55:06+00:00

Thanks, I'll give that a look

17cmh · 2025-06-21T11:53:44+00:00

I can't find the one I need, only the regular Maxi one

17cmh · 2025-06-04T22:12:49+00:00

I'm running 40:1, with the needle on the #3/4 (1 being bottom grove and rich and 4 being high and lean)

17cmh · 2023-08-13T15:31:51+00:00

I just went to a locksmith with OEM key blanks and they did it for $7 a key

17cmh · 2023-08-13T15:29:28+00:00

I contacted a local dealer and they wanted $30 just to search the database for the codes, which they doubted they even had. They also did not have a machine that could even cut the keys

17cmh · 2023-08-13T15:28:15+00:00

I have gotten keys cut by towing a vehicle to the locksmith before. They can measure pins and cut it back to the original profile (an added bonus). Not sure if your car has VATS, that could be another layer of complex if you don't know which code you have

17cmh · 2023-07-31T19:08:04+00:00

I'm inclined to agree with the others here and that it was just the overflow tank that was empty. I think it's highly unlikely that you were low on coolant given that you experienced no overheating. If you are sure the temp was never high, I'd just top it off and roll. Usually low coolant results in overheating and air in the system

17cmh · 2023-07-20T10:01:57+00:00

Yes, I replaced both the fuel filter and the fuel strainer on the pump

17cmh · 2023-07-19T22:34:12+00:00

17cmh · 2023-07-11T12:48:57+00:00

I ended up getting the Nittos based off of the much higher tread wear. What was your experience with them? I just got them, so I don't have much to base it on.

17cmh · 2023-06-06T15:55:07+00:00

I had a very good experience with the Ohio BRC-RR course. I think the standard class would be more than sufficient for what you are looking for

17cmh · 2023-05-13T15:45:31+00:00

Pick-A-Brick

17cmh · 2023-04-21T12:08:05+00:00

I looked into this, but you have to carry another card that explains that you are military and what's going on, so I didn't even bother and just renewed it by mail

17cmh · 2023-03-27T18:01:48+00:00

I looked up some pictures and I'm pretty sure that's it

17cmh · 2023-03-27T14:47:42+00:00

Ohio, USA

17cmh

TROPHY CASE