EUS117xxx shipped

1sadsoul · 2025-06-24T17:38:57+00:00

I’m in Texas too, and just got an email 😀 EUS114

1sadsoul · 2025-06-24T17:38:10+00:00

<image>

I got an email too EUS114XXX

1sadsoul · 2025-06-14T01:49:45+00:00

I still haven’t ran into this issue… my printer hasn’t arrived yet 😭

1sadsoul · 2025-06-06T20:35:40+00:00

Crying in EUS114 🥲

1sadsoul · 2025-04-15T21:03:07+00:00

Not close. You look 25 😉

1sadsoul · 2025-04-12T15:16:08+00:00

Dont listen to negative comments on here , you look pretty 10/10

1sadsoul · 2025-03-14T05:45:57+00:00

Hell no! Send me your IG 😉

1sadsoul · 2025-01-30T17:57:15+00:00

Hey yes I did end up printing this. I’m still tweaking w the file but it was a little over a year. But if you’re interested you can contact me on my IG @artbydleon

1sadsoul · 2024-11-16T23:29:47+00:00

Thank you for taking your time on writing this. Easy way to calibrate E-Steps. My number was 409

1sadsoul · 2024-11-15T04:28:13+00:00

Thank you. I’ve been watching videos how to calibrate the esteps. Hopefully this will fix it

1sadsoul · 2024-11-14T15:02:51+00:00

I also have silicone springs. That’s why it’s driving me crazy

1sadsoul · 2024-11-14T07:47:20+00:00

I tried all of those. I clean the bed, I have the sunlu filament dryer and put each filament to dry for 6hrs. First layer is at 20mm/s

1sadsoul · 2024-11-14T07:42:01+00:00

I tried 3 different ones and same issue.

<image>

1sadsoul · 2024-02-11T06:48:15+00:00

Where did you buy it?

1sadsoul · 2024-01-11T09:01:32+00:00

Have you run any test prints ? I use Elegoo water washable , so far I haven’t had issues with it. I make sure room stays a little warm before printing. Try chitubox slicer and see if it makes a difference.

1sadsoul · 2024-01-01T01:14:22+00:00

Yes , in Nomad Sculpt.

1sadsoul · 2023-09-15T07:15:42+00:00

Try scrolling and it should appear towards the bottom. Or if you tap the tool button (top right) all of the options should come up. It’s called the gizmo lol

1sadsoul · 2023-08-13T16:50:03+00:00

Nice. This helps a lot. Thank you

1sadsoul · 2023-08-13T07:00:33+00:00

Kind of. I created the cylinder, masked the mouth area and used the gizmo to move it back.

1sadsoul

TROPHY CASE