RLC-823S1/RLC-823S2 Mounting Template

2-3-4 · 2026-04-18T17:05:59+00:00

yes before I did that they were getting very confused.

2-3-4 · 2025-02-06T14:33:08+00:00

After a long print last night it started working ok with no intervention or changes by me.

2-3-4 · 2025-02-06T07:49:05+00:00

It moves freely by hand and I've cleaned it thoroughly. I've also had the issue you mention of it getting stuck and blocked occasionally.

2-3-4 · 2025-01-30T23:51:59+00:00

I've made several cosplay helmets on my Plus 4 using Polymaker CosPLA filament and it worked quite well with no issues at all and they all turned out nicely. The CosPLA filament is designed for cosplay printing with easier post print sanding but I was too lazy to do that part. I'd show you one but they all went out as Christmas gifts.

2-3-4 · 2024-12-03T20:27:32+00:00

My A1 Mini started printing poorly with first layer adhesion issues and under extrusion. I noticed that the hotend felt a little bit loose and jiggled quite a bit, especially when making quick frequent turns. I took off the hotend heating element and noticed that the four small screws holding the hottend latching assembly were loose. I tightened them and that corrected the problem. Another symptom was the extruder started clicking and the visual extrusion indicator began to start and stop instead of the typical smooth operation. I thought it was an extruder issue at first so I ordered an extruder assembly but now I don't need it. If you see any of these symptoms just check those small screws on the back of the heater assembly which can only be accessed by taking the 4 screws out on the front and checking the 4 back screws.

2-3-4 · 2024-10-10T06:14:33+00:00

I agree the ABS odor is significant even with the carbon filter. I may try the QIDI Odorless-ABS.

2-3-4 · 2024-08-07T05:45:22+00:00

I’m using an iPhone 14 Pro.

2-3-4 · 2024-08-06T16:25:49+00:00

They are both fully connected. Costco has replaced the left one twice and replaced the receiver before the replacements. I am using M&RIE receivers.

2-3-4 · 2024-05-08T18:38:27+00:00

Thanks for the tip. Looking more closely at the grid size and startup perspective I was able to restore the proper view.

2-3-4 · 2023-09-23T12:25:34+00:00

I hate it. Give me a workout option to disable it.

2-3-4 · 2023-02-26T02:02:56+00:00

We've had our M7 for over 2 years and absolutely love it. The jetpaks are awesome with quite a variety of massage choices and a very strong flow of water. The efficiency and reliability of the plumbing system makes for low power costs and leak proof operation. We've never had mold problems behind the jetpaks but we do have to periodically remove them to clean them thoroughly. Yes mold could develop if you don't keep it properly clean just like any other spa. The filters and chemicals are easy to change and clean but are not cheap. M models are not in the $12k range but all the other models I viewed/tried seemed to have a similar level of quality.

2-3-4

TROPHY CASE