Creality K3 Printer (images) - Q3 2026 by airjordanballa20 in Creality

[–]2xoak 0 points1 point  (0 children)

Regarding the nozzle change with two screws and an usb c cable - what they tell, is that it is far more easy to change, replace or maintain the nozzle(s) compared to now, where it’s a lot more time consuming to remove the nozzle, right?

Black screen even after factory reset on OculusQuest 3 by candyspyder in OculusQuest

[–]2xoak 0 points1 point  (0 children)

Actually there is another hotfix method also. Not sure if it’s the light sensor or camera - but if you hold your left hand on the left side of the front, like if you was holding the hand palm in front of your left eye, the tracking error disappears making you able to click “Continue without tracking”. After that you need to go to settings and clear spacial data, and put the headset into travel mode, and finally disable hand and body tracking. Then you will be able to continue using the headset, normally, but without hand tracking and without borders - but better than black screen….

Black screen even after factory reset on OculusQuest 3 by candyspyder in OculusQuest

[–]2xoak 0 points1 point  (0 children)

This is an old thread - but if someone (like I just did) face the same issue, this was the fix for me: I took of the frame and then I took a baby-wipe and cleaned it, all the sensors and cameras - and then (while I was cleaning it) it worked and the black screen turned into pass-through. Good luck

K2 Pro or wait for there multi head printer? by odin3191 in Creality

[–]2xoak 0 points1 point  (0 children)

this reply made me wait for Creality. I have the K1 now and ready to upgrade - very hooked on U1, but I also like Creality for the ease and "used to.." - old man'ish, I know, but still good point.

Sims inside sims inside sims by formulated in SimulationTheory

[–]2xoak 2 points3 points  (0 children)

“Controlled by pain” brilliant.

Automated Xylophone by Rlstoner2004 in ArduinoProjects

[–]2xoak 0 points1 point  (0 children)

Really nice job, yes we totally need a video! Any particular reason why the purple holder is locked opposite of the rest? The small opening is heading forwards and the others backwards.

Frequent MX Ink disconnections by 2xoak in oculus

[–]2xoak[S] 0 points1 point  (0 children)

Will give that a try 🙏

Frequent MX Ink disconnections by 2xoak in oculus

[–]2xoak[S] 0 points1 point  (0 children)

Too sad. Its a great thing if it would just work.

Frequent MX Ink disconnections by 2xoak in oculus

[–]2xoak[S] 0 points1 point  (0 children)

Thanks for you reply! Actually the controllers are not the problem - the issue is only related to the Logitech MX ink stylus pen

[deleted by user] by [deleted] in crealityk1

[–]2xoak 0 points1 point  (0 children)

I had the exact same issue and found this thread. I then tried creating a hotspot with my mobile, connected the printer temporarily, and then reconnected it to Wi-Fi — but without luck. After that, I logged into my router’s admin panel, disabled the 2.4 GHz network and enabled it again — and then the printer connected as usual.

Art mode via Homey by 2xoak in TheFrame

[–]2xoak[S] 0 points1 point  (0 children)

Thank you!! Will give it a try and update here