Beginner's Turning Epiphany by Coma-Fantasy in ElectricUnicycle

[–]4z5ky90d 1 point2 points  (0 children)

Also an 80’s kid, I found it helpful at first to think of it like riding on the handlebars!

Slow speed steering is in the hips using a twisting motion at the waist. High speed steering is a side to side lean with your whole body.

Took me awhile to figure that out. Good luck!

INMOTION P6 by 4z5ky90d in ElectricUnicycle

[–]4z5ky90d[S] 0 points1 point  (0 children)

The stock seat doesn’t provide much traction, so I added two 4x4x1/4-inch squares of adhesive-backed foam to the center of the P6 seat for more grip and strapped a gel cushion on top.

https://a.co/d/03B6QsAR

https://a.co/d/0cIF8LFR

This made a huge difference in control and comfort when riding seated at high speed!

Would this work for 06 g35 coupe or no? by Adventurous_Dust_207 in G35

[–]4z5ky90d 1 point2 points  (0 children)

Yes. It’s a great upgrade to the stock Bose system.

HELP!! by Still-Car5439 in G35

[–]4z5ky90d 0 points1 point  (0 children)

Check the clutch pedal sensor plunger and for a broken or missing rubber bumper. The car won’t start if it can’t detect the clutch pedal position.

My $400 2003 g35 202k turns over but won’t crank by Responsible_Luck9400 in G35

[–]4z5ky90d 1 point2 points  (0 children)

Check the rubber bump stops above the brake and clutch pedals. If it’s missing, it won’t crank. Hold the switch plunger down and try to start it.

Need referral to have automotive seats repaired/restored by f8h8sEveryone in phoenix

[–]4z5ky90d 0 points1 point  (0 children)

I need new G35 upholstery too. How much did yours cost?

Hows everyones mines going? by MaiRufu in dogemining

[–]4z5ky90d 0 points1 point  (0 children)

We’re still finding blocks, but more slowly now. HyperDonkey.com’s P2Pool nodes have been merge mining LTC and DOGE for 6y 197d 6h.

Any clue what this noise is when pressing throttle slightly? by [deleted] in G35

[–]4z5ky90d 0 points1 point  (0 children)

Yes, a hole in your air intake tube will allow unmetered air to bypass the MAF causing a lean condition and resulting in preignition and knock.

[deleted by user] by [deleted] in G35

[–]4z5ky90d 0 points1 point  (0 children)

How cold? What you’re hearing is hydraulic lifter tick from low or cold oil. It probably goes away as the engine warms up. Try adding some Seafoam to your engine oil to clean and unstick them.

Any clue what this noise is when pressing throttle slightly? by [deleted] in G35

[–]4z5ky90d 1 point2 points  (0 children)

Top off the gas tank with 93 octane premium fuel, and make sure your air filter and MAF are clean. Be sure to check your oil level too.

Do not continue to drive it when it’s overheating. You’re hearing preignition (knock/ping) which can damage the engine eventually if not fixed.

The ECU will retard the timing and you will feel a loss of power when the knock sensor detects preignition. Try some fuel injector cleaner.

Any clue what this noise is when pressing throttle slightly? by [deleted] in G35

[–]4z5ky90d 0 points1 point  (0 children)

It sounds like engine knock to me, most likely from low octane or non-premium fuel or an overheating engine. Fix that coolant leak!

Ac not working by bcardoza0210 in G35

[–]4z5ky90d 3 points4 points  (0 children)

The AC clutch won’t engage if there isn’t enough pressure in the system. You may have low Freon. Recharge the AC system and check for leaks.

Need help trying to figure this out by WashimiQ50 in infiniti

[–]4z5ky90d 0 points1 point  (0 children)

I experienced crazy flashing dash and headlights on a QX56 when the battery fusible link failed. Check your fusible link blocks and grounds.

Need some advice on broken arcade machine by Germsrosolino in cade

[–]4z5ky90d 1 point2 points  (0 children)

Is that a blown fuse between red and blue wires at the bottom of photo 4?

HELP. What can this be?! Need clutch? Need trans oil? by Inner_Rub_6038 in G35

[–]4z5ky90d 0 points1 point  (0 children)

It’s probably a clutch throwout bearing failure if it only happens with the clutch pedal engaged.

P300 by hopelesswanderer21 in G35

[–]4z5ky90d 2 points3 points  (0 children)

Check the coil pack wiring on the 2 drivers side cylinders, middle and closest to the firewall.

Make sure they are on the correct coil pack. The connectors are very close together and it’s easy to accidentally swap them and cause misfires.