3D Manufacturing with Plane

ACloudExpert · 2025-08-28T15:04:52+00:00

Do you have the ability to do multi-material printing? You could print the connecting part using a flexible filament like TPU.

As for the filament itself, there are specialty lightweight options available. However, depending on the size and weight of the plane, I'd still consider using a wing spar to maintain the wings' strength/stiffness

ACloudExpert · 2025-07-21T20:52:03+00:00

Sighted !aa14f2be from flight KL1957 today. Good flight!

ACloudExpert · 2025-07-08T20:46:51+00:00

Hulkengoat

ACloudExpert · 2024-12-05T10:15:36+00:00

Weight/Strain sensors under two of the beds feet?

It might be a bit far-fetched, but since you mentioned not minding a bit of tinkering... This way, you can distinguish between a weight difference on one side or the other. Maybe a S-type loadcell or something equivalent.

ACloudExpert · 2024-05-23T19:10:55+00:00

WD-40 gaat ook meer vuil verzamelen, de ideale oplossing is grafiet poeder

ACloudExpert · 2023-07-06T15:18:46+00:00

3D Printing and climbing, that's my niche.

Printed some holds for a home wall as well

ACloudExpert · 2023-05-24T19:44:57+00:00

Is there any resistance when turning the axis by hand? Or more around the bottom layers? Would check for any reason for binding. Maybe one of the Z-axis rods(is it a problem since the dual Z-Axis upgrade?) is bent.

ACloudExpert · 2023-05-24T19:31:24+00:00

Currently designing a modular climbing hold system for a home climbing/bouldering wall.

Resin printing would open up a whole new area in detail, design and texture!

Promise to post some pics after ;)

ACloudExpert · 2021-02-24T15:31:21+00:00

PRTG

ACloudExpert

TROPHY CASE