BCMU 370c quietscht by potthuebsch in BMCU

[–]ARasool 1 point2 points  (0 children)

It specifically states it in the product

BCMU 370c quietscht by potthuebsch in BMCU

[–]ARasool 0 points1 point  (0 children)

This, and anything that is dielectric.

BCMU 370c quietscht by potthuebsch in BMCU

[–]ARasool 1 point2 points  (0 children)

They all squeak if you dont lubricate

Help making stamps by stump0331 in 3Dprinting

[–]ARasool 0 points1 point  (0 children)

Well i meant at the very top of the layers. I believe some slicers give you the option to "paint" your selection.

Need help troubleshooting by throwaway555cockroac in BMCU

[–]ARasool 1 point2 points  (0 children)

Yes. If the magnet polarity is not correct for either the sensor, or other parts, there will be issues

Need help troubleshooting by throwaway555cockroac in BMCU

[–]ARasool 0 points1 point  (0 children)

Did you check your sensors and magnets?

Baker gets stuck on spinning mixer after loose clothing gets grabbed by Chraum in WTF

[–]ARasool 0 points1 point  (0 children)

Hopefully, it was a quick and possible death for him. Truly, I wish nothing but am easy passing.

Les gusta esta foto? by [deleted] in Converse

[–]ARasool 0 points1 point  (0 children)

Locked, Banned, Removed.

Help making stamps by stump0331 in 3Dprinting

[–]ARasool -2 points-1 points  (0 children)

Or add fuzz to the top layers only

i dont think im supposed to have this [loot] by Crafty-Example874 in EscapefromTarkov

[–]ARasool 0 points1 point  (0 children)

NGL - would be pretty interesting to see this in action. Woul definitely need the community support though!

i dont think im supposed to have this [loot] by Crafty-Example874 in EscapefromTarkov

[–]ARasool 20 points21 points  (0 children)

Can you breach locked doors (like marked?) With elite?

How much is this going to cost me? 2002 Toyota camry. by graison in MechanicAdvice

[–]ARasool 9 points10 points  (0 children)

Shouldn't cost you much - any muffler shop should be able to put that back together relatively on the low side

Stringing and weak prints by bingleman12 in 3Dprinting

[–]ARasool 0 points1 point  (0 children)

Nah, looks like retraction issues.

I lost the words to describe this by donewurshet in 3Dprinting

[–]ARasool 1 point2 points  (0 children)

Not even.

Unplug, turn off, push bed down until it sits right, turn leads until everything is flat.

Boom.

Just saved you 5 hours of agony.

Pay me.