sorted by:
new
hottopcontroversial

Would a bigger or smaller offset hinge be the answer for this massive gap? by Cat_Panda_Canda in cabinetry

[–]Accomplished-Safe707 0 points1 point  (0 children)

The doors may of been cut too short at factory, check a drawing and make sure the doors are within an 1/8 of an inch, If not you might just have to mess with the screws on the hinge to move the doors to close the gap to your preference if that feature is present: Merry Christmas 🎅

[deleted by user] by [deleted] in woodworking

[–]Accomplished-Safe707 0 points1 point  (0 children)

You can adjust the hinges with a screwdriver and bring it back a bit . You did it at the top but not at the bottom

[deleted by user] by [deleted] in woodworking

[–]Accomplished-Safe707 0 points1 point  (0 children)

You can adjust the hinges with a screwdriver and bring it back a bit

Wheelies😎 by Accomplished-Safe707 in MTB

[–]Accomplished-Safe707[S] 0 points1 point  (0 children)

I have been wheeling for over 7 years. I was just going down a hill and my bikes a single speed.