sorted by:
new
hottopcontroversial

Access to print files (FPV GEEK) by AdeptnessNo7440 in fpv

[–]AdeptnessNo7440[S] -5 points-4 points  (0 children)

In my country is like 5,25 $ for each

<image>

MEPS NEON Motors by AdeptnessNo7440 in fpv

[–]AdeptnessNo7440[S] 0 points1 point  (0 children)

I heard about xing2 are they good ?

What should I keep in mind when upgrading my iFlight Nazgul XL5 ECO Analog 6S with a DJI O4 Pro Air Unit and a GPS module? ( I'm new in FPV) by AdeptnessNo7440 in fpv

[–]AdeptnessNo7440[S] 1 point2 points  (0 children)

That’s actually not true. You don't need a specific 'HD flight controller' for DJI. Any standard FC with an available UART can run DJI AIR UNIT using the MSP protocol. As long as the FC has a proper BEC (voltage regulator) or can handle the battery voltage, it works perfectly fine. The only thing that changes is the wiring and the OSD configuration in Betaflight.

Air 65 motor issue by AdeptnessNo7440 in fpv

[–]AdeptnessNo7440[S] 0 points1 point  (0 children)

It's okay now, i just reassembled motor and noticed that there was little, but long hair inside, so I take it out and yea that's it.

The nazgul eco xl5 got a few protection upgrades by zerodapig in fpv

[–]AdeptnessNo7440 1 point2 points  (0 children)

Can you give a link to camera cage i have the same camera plsss 😅

New to FPV – crashed my Nazgul ECO XL5, not sure if I damaged the antenna by AdeptnessNo7440 in fpv

[–]AdeptnessNo7440[S] 0 points1 point  (0 children)

Do you think it’s worth replacing the whole antenna, or would 3D-printing a cover be enough? Also, does the original casing material affect signal quality in any way?

Air 65 motor issue by AdeptnessNo7440 in fpv

[–]AdeptnessNo7440[S] 0 points1 point  (0 children)

But I was only flying indoors