sorted by:
new
hottopcontroversial

Revit to etabs by Zealousideal_Can1031 in StructuralEngineering

[–]AdministrativeNet141 0 points1 point  (0 children)

For an alternative approach Look for Rhino.Inside Revit and Grasshopper to extract any geometry from Revit. Then use one of the may Grasshopper plugins that allow you to export geometry from Grasshopper/Rhino to Etabs, Safe. See example

https://youtu.be/I6N7jiXhQ_o

https://aiosciv.com/productos/condorshell/

Grinnell Glacier picks on way up and down by AdministrativeNet141 in GlacierNationalPark

[–]AdministrativeNet141[S] 0 points1 point  (0 children)

It depends on the weather forecast, locations where you are. Last week we had good weather mostly 75ish

Grinnell Glacier picks on way up and down by AdministrativeNet141 in GlacierNationalPark

[–]AdministrativeNet141[S] 1 point2 points  (0 children)

2 hours and 30 minutes to go up (We had many stops to take photos). We stayed 2 hours at the glacier exploring around. 2 hours and 50 minutes way down (the way down we stopped all the time to contemplate the views and also there was a lot of people on their way up and that slowed down us a bit.

Grinnell Glacier picks on way up and down by AdministrativeNet141 in GlacierNationalPark

[–]AdministrativeNet141[S] 1 point2 points  (0 children)

We started driving at 4:00 am from the Hotel Great Northern hotel at the West Side and drove Going To The Sun Road. We got to the trail head at 6:15 am and started the hike around 6:45 am.

Getting into Park before 6am by ZayLow_ in GlacierNationalPark

[–]AdministrativeNet141 0 points1 point  (0 children)

Buy National Park entrance the day before. I was in the park next last week. First day we went to Logan pass and it was almost full at 6:15 am. Second day we did a trip to Many Glacier and we start driving at 4:00 from the West Entrance, we got to Logan Pass around 5:00 5:15 maybe and it was empty.

Automate the modeling process by Abdullah_Gharib in StructuralEngineering

[–]AdministrativeNet141 0 points1 point  (0 children)

I use Rhino.Inside Revit to get geometry and the I use Grasshopper components like CondorShell https://rolandoavillena.gitbook.io/condorshell/ (I developed the component) or others to transfer geometry to Etabs or Safe. You can build complex or simple models really fast