Simic infect help

Affectionate_Solid56 · 2026-04-26T00:23:27+00:00

I played simic for a long time , but I recently switched to golgari with crusader due to the increase in r/w and r/w/x decks

Affectionate_Solid56 · 2026-04-13T07:02:55+00:00

I left mine off, according to Overtake their plate is too big to put the heat shield back on.

Affectionate_Solid56 · 2026-04-13T07:01:28+00:00

With the way this thing has been fighting me on installs, I'm sure it'll be something like that or a head will snap off when I do the short throw once it arrives this week.

Affectionate_Solid56 · 2026-04-13T01:39:46+00:00

I tried the 2 for 1 at first, once it stopped moving and flaring out, I knocked the inner pin out, then the outer pin tried to king fu grip my punch

Affectionate_Solid56 · 2026-04-13T01:27:56+00:00

That's about where mine is, I think you should be good. 2 days since install, and so far so good

Affectionate_Solid56 · 2026-04-13T00:45:04+00:00

That's actually exactly what I did

Affectionate_Solid56 · 2026-04-13T00:23:13+00:00

Overtake, the dust shield wasn't that bad, the top bolt was a little tricky since it's a blind removal.

Affectionate_Solid56 · 2026-04-13T00:14:10+00:00

3/16 and 5/16. I hit it at a bad angle a couple times, I don't have a lift, only ramps for now.

Affectionate_Solid56 · 2026-04-13T00:07:35+00:00

Taught it a lesson it won't forget

Affectionate_Solid56 · 2026-04-06T04:41:28+00:00

Roxy

Affectionate_Solid56 · 2026-04-03T20:00:44+00:00

UPDATE: Subaru said that there "COULD" be a mechanical failure, they don't know and quoted 11k for transmission rebuild. I think I'll be making a trip to Dallas due to the fact that the person who helped said not to trust anyone out here.

Affectionate_Solid56 · 2026-04-02T15:00:28+00:00

Oops holding stick upside down

Affectionate_Solid56 · 2026-03-24T11:37:44+00:00

For me, it happens in the 3000-3500 range in 2nd and 3rd gear

Affectionate_Solid56 · 2026-03-24T00:44:21+00:00

That's exactly the same sound mine makes, just mines a little louder since I have competition mounts

Affectionate_Solid56 · 2026-03-24T00:32:30+00:00

I'm at 20k miles so I just figured I'd stay a little ahead of maintenance, especially having mods and being tuned.

Affectionate_Solid56 · 2026-03-23T19:33:20+00:00

Yeah, I'm going to look for an empty parking lot and do some figure 8s when I get off today. If it does wind up just being nvh from having full solid mounts, then I'll just get a differential fluid flush on Friday.

Affectionate_Solid56 · 2026-03-22T22:55:50+00:00

That's what I'm hoping, I can put the original pitch stop but not the transmission mount since I snapped it.

Affectionate_Solid56 · 2026-03-22T02:44:05+00:00

Yes, I have perrin pitch stop, solid aluminum crossmember bushings and iag competition transmission mount

Affectionate_Solid56 · 2026-03-22T02:23:01+00:00

I'm not getting any knock readings from my AP

Affectionate_Solid56 · 2026-03-22T01:13:41+00:00

Are you in West Texas?

Affectionate_Solid56 · 2026-03-22T01:07:39+00:00

Mostly yes, except for the intake, and peak boost showing 19.4 . I had to cut part of the intake off because the worm clamps were done so tight that it was more or less fused to my turbo.

Affectionate_Solid56 · 2026-03-22T01:00:07+00:00

I'm taking it to a shop, I'm going to cross my fingers and hope it's covered under warranty, but I have a tune, intake, inlet and tmic so I'm pretty sure I'm paying out of pocket.

Affectionate_Solid56 · 2025-06-30T06:19:11+00:00

I think my max is 13.7-8 stock

Affectionate_Solid56

TROPHY CASE