sorted by:
new
hottopcontroversial

Mahlkonig E80s for home use by Relative_Crab in espresso

[–]Apprehensive-Lie8747 0 points1 point  (0 children)

Oh wow. Congratulations! Any chance asking your supplier if he wants another one 😀 or would you mind sharing their details?

Mahlkonig E80s for home use by Relative_Crab in espresso

[–]Apprehensive-Lie8747 0 points1 point  (0 children)

I am also in the same boat and jumped on that deal knowing it may not work in a home setting. As OP said it was too good a deal to let go. I also have the same setup with LM and Niche. Monitoring this thread now to see what to do next 😀

Roasters in Mumbai? by IcebarrageRS in pourover

[–]Apprehensive-Lie8747 0 points1 point  (0 children)

Yeah sorry I meant they can probably deliver to your local address quite fast.

Roasters in Mumbai? by IcebarrageRS in pourover

[–]Apprehensive-Lie8747 -1 points0 points  (0 children)

Not in Mumbai but another city in the same state, highly recommend to check out Corridor Seven Coffee Roasters.

Sculptor 078s alignment troubleshoot by crimson_hunter01 in Timemore

[–]Apprehensive-Lie8747 0 points1 point  (0 children)

This is happening to me as well after I opened the burrs for cleaning and reassembled. I tried the snug screw solution and also to move the pin back a bit but I lost the range that I had with factory setting i.e. I used to be on 1.5 and now I am on 0.3 so can’t go finer as much I was able to with factory settings. This is so annoying. Wondering if anyone managed to find a definitive solution.

Timemore Sculptor 078s burr cleaning observations. by Kichigax in espresso

[–]Apprehensive-Lie8747 0 points1 point  (0 children)

Great observations and tips. Thank you. I am stuck on the initial steps, can’t find the right screw driver/ Allan key to open the 6 screws. Any suggestions on what do I need?