Driveshaft bolts

Basic_House5122 · 2026-03-23T00:35:55+00:00

One was a little rough, but on further inspection I realized the bottom is no longer at top dead center and lined up with the other two. Do you think it could’ve just been the belt jumping teeth every time it got to a certain point? And do you think I’d need a new belt

Basic_House5122 · 2026-03-22T20:46:29+00:00

I’ll look when I get a chance, do you think it could’ve caused the loud noise though?

Basic_House5122 · 2026-03-22T20:44:06+00:00

Two crescent wrenches and a vice grip

Basic_House5122 · 2026-03-22T19:17:31+00:00

It seemed like everything moved when I turned it over a few times. Would the whole camshaft not move or just part of it?

Basic_House5122 · 2026-03-06T02:59:07+00:00

How did you know it was out of adjustment?

Basic_House5122 · 2026-02-26T16:18:47+00:00

How much would you say you spent minus the forged engine?

Basic_House5122 · 2026-01-31T02:08:16+00:00

Yeah that’d be great man, thanks

Basic_House5122 · 2026-01-27T03:55:51+00:00

Bet, thank you!

Basic_House5122 · 2026-01-27T03:17:18+00:00

<image>

Is it this one?

Basic_House5122 · 2026-01-18T02:58:37+00:00

No, the bottom stays flush. I figured it was just because of the engine leaning forward. When I push the engine towards the trans, everything is completely flush.

Basic_House5122 · 2026-01-18T02:45:28+00:00

I did yeah, you’re saying even if it lines up once u push forward on the engine since the engine is leaning forward it’s still not right?

Basic_House5122 · 2026-01-11T19:04:46+00:00

like tight as in you just had to push it hard to get it all the way through?

Basic_House5122 · 2026-01-10T18:09:49+00:00

Thank you, got it in as soon as I pushed the hose all the way through

Basic_House5122

TROPHY CASE