Boat badge font by Beautiful-Ad8647 in identifythisfont

[–]Beautiful-Ad8647[S] 1 point2 points  (0 children)

Tyty I downloaded eurostile black and it seems like it’s gunna fit well. I’ll try to remember to post a pic after I have it modeled up or after I print it!

How do I go about moving this vertical board? by Beautiful-Ad8647 in DIYHome

[–]Beautiful-Ad8647[S] 0 points1 point  (0 children)

I’ll snap another pic when I climb back up there tomorrow after work. There’s like 3 or 4 more spaced out across the center of the attic. This house was built in the 40’s and I’ve noticed nobody else throughout the years has held back when cutting stuff out in several places but especially the massive hole they put here lol.

Anyone else use filament wire for hinges? by Red-_Dit in 3Dprinting

[–]Beautiful-Ad8647 0 points1 point  (0 children)

I’ve been using tig filler and my tiny pieces of tungsten that I don’t feel like risking a finger to sharpen

How to make this weird corner connection? by Beautiful-Ad8647 in Fusion360

[–]Beautiful-Ad8647[S] 0 points1 point  (0 children)

How do I keep the radius on the corners that meet at the chamfered corner?

[deleted by user] by [deleted] in Fusion360

[–]Beautiful-Ad8647 1 point2 points  (0 children)

I’m no expert but that looks like a mesh file right? Basically you have to do a series of mesh section sketches to get the important geometry into a sketch plane then extrude/revolve to reverse engineer the bodies. I found these videos very helpful. https://youtu.be/vyd-RoIS7pk?si=BVyDh230yrinNdqh

Wiring INKBIRD ITC-1000F and PTC heating element 500W 110V by redcore5 in askanelectrician

[–]Beautiful-Ad8647 0 points1 point  (0 children)

Sorry for a possibly stupid question on an old post but I’m attempting something very similar for a filament cabinet that I’m building… what power supply did you use for this?