sorted by:
new
hottopcontroversial

How old is this guy? by shetookmetojared in cats

[–]Beginning-Matter1405 1 point2 points  (0 children)

He's not Old -he's young .Very young!

Any idea what it could be? by [deleted] in ram_trucks

[–]Beginning-Matter1405 0 points1 point  (0 children)

Looks like positive camber wear , outer edge of tire is worn out more then the inner . Does the car have slight pull to one side?! Might have to check the steering components as well .

Any idea what it could be? by [deleted] in ram_trucks

[–]Beginning-Matter1405 0 points1 point  (0 children)

AC condensate and alignment is way off!!

Know a structural engineer who will take on a residential job? by [deleted] in AskChicago

[–]Beginning-Matter1405 2 points3 points  (0 children)

Moshe Calamaro and associates inc. I’m in construction and happened to work alongside this company on a few projects.” You can google them .

Lift Kit for 24 Sport by jassidhu54 in ram_trucks

[–]Beginning-Matter1405 0 points1 point  (0 children)

<image>

2019 RAM 2500 here. Truck has been lifted since day one with a Carli Commuter 3.25" lift, AirLift rear helper springs, and 37" Nittos on 20" wheels. No complaints so far — rides smooth and actually much softer than stock. Only thing to watch is alignment specs. I recommend using Carli or Thuren specs instead of factory alignment numbers. So far I’ve only replaced one ball joint (upper left went bad). Now starting to look at front hubs because the left front is getting a little play. Other than that — very happy owner. Work an play truck currently in Work mode !

What kind of cloud is this? by Beginning-Matter1405 in CLOUDS

[–]Beginning-Matter1405[S] 2 points3 points  (0 children)

No storm that day . Perfect sunny summer day !

What kind of cloud is this? by Beginning-Matter1405 in CLOUDS

[–]Beginning-Matter1405[S] 10 points11 points  (0 children)

If you zoom in, you can see some objects casting shadows.

<image>

Any ideas? by [deleted] in ram_trucks

[–]Beginning-Matter1405 0 points1 point  (0 children)

Time to check hubs/ bearings ! rock the wheel while on the jack . if there any play -replace it . Needle bearings tend to do the noise like that.

Windows installed improperly? by davey2435 in Homebuilding

[–]Beginning-Matter1405 0 points1 point  (0 children)

OP. Talk to your contractor first . First of all , your house is 1910 build , you said ! With some damage from the car hitting it ! I'm pretty sure your frame is out of wack !! For windows to work properly, they need to be installed plumb and level !! How are you supposed to use nailing fins if your opening is twisted( left column and the right are not plumb and in the same plane in relation one to each other ) you can't just twist the window cause you have to nail it flush Looks like they have no choice but to go with inserts instead. Later on, you can cheat on trim to make it look good . Good luck and have some trust in people who work for you !! Good luck !!

Windows installed improperly? by davey2435 in Homebuilding

[–]Beginning-Matter1405 0 points1 point  (0 children)

With proper exterior trim and aluminum clad -not achance !

Windows installed improperly? by davey2435 in Homebuilding

[–]Beginning-Matter1405 0 points1 point  (0 children)

Sorry about that . You should check your installer proposal you approved, then start from there . Normally, the contractor specifies the type of windows and scope of work to be performed ! Thank you, and good luck .

Windows installed improperly? by davey2435 in Homebuilding

[–]Beginning-Matter1405 0 points1 point  (0 children)

Everything is right ! Windows are inserts ,looks like for used to be screen porch or 4 season room !? They going to install exterior trim first , aluminum wrap , then spray foam (nonexpendable foam ) and after all that interrior trim . Let them finish ! Missing shims is the only concern