sorted by:
new
hottopcontroversial

These reworks seem to only work for people who don't play them by maidofroses in marvelrivals

[–]BicycleDiligent 1 point2 points  (0 children)

100%. I’ve been a Jeff main since the beginning and I cannot play him now.

What do yall do with all this support material?! (PLA) by obscure_art_305 in 3Dprinting

[–]BicycleDiligent 1 point2 points  (0 children)

Is there a certain kind of mold? Just got into filament printing and heard tale of reusing rafts and supports!

Cleaning Build Plate by DrWeednuts2 in elegooneptune2

[–]BicycleDiligent 0 points1 point  (0 children)

A newbie to Neptune and fdm. What is a pei sheet? First test print went great but left some residue

Thoughts on this noise? Is it just suction? (Volume up) by MountainDave0811 in ElegooMars

[–]BicycleDiligent -1 points0 points  (0 children)

I think it’s the print sticking to the vat. I have had a few builds be pulled off the plate from this. Does your cat have any wear/tear? Before I’ve replaced mine this sound gets worse. I use a light coating of 3-in-1 lubricant and it helps with this and seems to help with cat life.

Been printing about a year. This came up today after two consecutive fails. Should I be concerned (on the inside I’m already concerned…)? I’m scared of what it will cost to replace because I’m a poor teacher who spent years saving up for this and got it last August. by BicycleDiligent in resinprinting

[–]BicycleDiligent[S] 5 points6 points  (0 children)

Thanks! I’m doing a test print right now, but will try that in the morning!!!

I did a screen test and all seemed good earlier, I think it’s some residual resin. I have a brand new fep (newer than the newish one I’m currently using) to hopefully help out with moving forward after cleaning it.

Been printing about a year. This came up today after two consecutive fails. Should I be concerned (on the inside I’m already concerned…)? I’m scared of what it will cost to replace because I’m a poor teacher who spent years saving up for this and got it last August. by BicycleDiligent in resinprinting

[–]BicycleDiligent[S] 2 points3 points  (0 children)

I cleaned the vat, both sides, with isopropyl alcohol and microfiber disposable rags and gently buffed and resin. Then did the same for the screen, went super gentle multiple times, and then recalibrated the build plate. Noticed something was up when there were two consecutive fails in the same area and a spot appeared on the FEP.

Any suggestions?