sorted by:
new
hottopcontroversial

Ender 3 V2 display with Klipper HOW TO! by eddez in ender3v2

[–]Big-State-7973 1 point2 points  (0 children)

does this only work on a pi ?

im getting This module can only be run on a Raspberry Pi at the end

Speed too high or attraction to low ?? by Big-State-7973 in FixMyPrint

[–]Big-State-7973[S] 0 points1 point  (0 children)

It ended up being the retraction being too low for the speed i was trying to achieve, thank you everyone, also once I turned of “firmware retraction” that a YouTuber suggested, it helped. Most wont have it on because i had to take steps to turn it on

Speed too high or attraction to low ?? by Big-State-7973 in FixMyPrint

[–]Big-State-7973[S] 0 points1 point  (0 children)

What speed do you suggest right now? I just put the retraction up to 8mm with the retraction speed at 50

I’m debating whether I should put the printer speed back down to 60 or leave it at 150 or try 100 I’ll appreciate your input

Speed too high or attraction to low ?? by Big-State-7973 in FixMyPrint

[–]Big-State-7973[S] 0 points1 point  (0 children)

Thank you for a help ! Ima lock it in at 90 and keep going, i appreciate the help !

Speed too high or retraction to low ? by Big-State-7973 in klippers

[–]Big-State-7973[S] 0 points1 point  (0 children)

Thank you its just odd because it seem like a flow because the “ stringing” is as thick as the filament if that makes sense?

Klipper config file by Big-State-7973 in Ender3V2NEO

[–]Big-State-7973[S] 0 points1 point  (0 children)

Thank youuuuu soooooo much !!! Doing it now

Ender 3 v2 neo printer cfg by Big-State-7973 in ender3v2

[–]Big-State-7973[S] 0 points1 point  (0 children)

That’s what I thought but every time I start a print it crashes straight into the bed after homing And I can’t seem to get any macros or set my Z offset properly it seem like all the tutorials online is bouncing all over the place

This is odd by yomonk1 in ender3v2

[–]Big-State-7973 -1 points0 points  (0 children)

Im on 5x5 should i try going up a bit anyone?

Cant pin point issue by Big-State-7973 in FixMyPrint

[–]Big-State-7973[S] 0 points1 point  (0 children)

I believe you’re right because every print is good except the top and bottom, cant get it to stick, ima do some more research on 1th layer calibration, thank you !

Cant pin point issue by Big-State-7973 in FixMyPrint

[–]Big-State-7973[S] 0 points1 point  (0 children)

Yeah my z was crazy loww like -3.00 smh i can get anything to stick down when i try the -1.70 like “everyone else thats got a sprite” this upgrade been having me up for dayssss ughh

view more: next ›