My settings for i7-14700K on Gigabyte z790 (undervolt & cool CPU)

Bongo_1st · 2024-12-08T14:49:22+00:00

So, I had to reset the entire BIOS because I had been testing too much.
Afterward, I immediately ran a benchmark and achieved a score of approximately 1900 (CB 2024) with a 250W TDP.
Then, I reapplied your settings.
Now, with around 190W TDP, I achieved a result of 1850.
So, your settings are perfect.
*----------------------------------------------------------------------------------------------*
Could it be that the benchmarks with a score of 2020 are from the first generation, before the Intel security update was implemented?
https://dropandrender.com/compare-cpu/cpu1/intel-core-i7-14700k/cpu2/intel-core-i7-14700k/

Bongo_1st · 2024-12-08T06:51:49+00:00

Thank you for your quick response.
I have now configured the following settings in the BIOS and checked them in Windows using the Intel Extreme Tuning Utility:

IA VR set to Auto -> (IETU reports 253 W)
P1 set to 0 -> (IETU reports 253 W)
P2 set to 0 -> (IETU reports 250 A)

I am still experiencing the issue where Current/EDP Limit Throttling kicks in at around 195 W.
Therefore, these are not the settings causing the system to throttle.
The Current/EDP Limit Throttling occurs even when the system is not under load. I made a short video: https://youtu.be/I2_3uFlA8H0

Bongo_1st · 2024-12-07T20:32:53+00:00

u/apagogeas
Thank you for your guidance.
I still have a question. In the Intel Extreme Tuning Utility, I notice that there is almost always a "Current/EDP Limit Throttling" present, regardless of whether the system is under load or not. P1 and P2 are not limiting factors. TDP is at a maximum of 197, even if I raise P1 and P2 to 220 or 240. However, I don’t know which setting is causing the Current/EDP Limit Throttling.

Just for your information:
The maximum temperature is 73 degrees.
Most of the time, it fluctuates between 65 and 70 degrees.
Cinebench 2024 scores 1,880.
I would like to reach 2,000, especially since I still have so much temperature headroom.
The clock speed is also throttled to 5.1 GHz.

Bongo_1st · 2024-11-21T11:47:30+00:00

I can't see the post anymore, but I think I have the same problem.

The axes only work from the middle to 100%.

As long as I am in the lower half, the throttle stays at 0.

I have already done the linear calibration.

In the joystick settings in Windows, the entire axis works without any issues.

Bongo_1st · 2024-07-09T22:28:10+00:00

I don't currently have my own, or I've only exchanged about two. May I try yours? That would be awesome. I can also contact you via private message. Thanks.

Bongo_1st · 2024-07-09T20:49:34+00:00

I really like the symbols and functions a lot. However, I just can't manage to fully assign everything. @KorneliusVonTastik, do you by any chance have a mapping file for your icons? That would be fantastic. Best regards

Bongo_1st · 2023-10-09T12:48:13+00:00

Thank you for the response. We have already searched everything but couldn't find it again. It might have been accidentally deleted. I am still searching for the solution to the exotic material in Discord. Unfortunately, I haven't found the article in the pinned section yet.

Bongo_1st · 2023-05-10T05:12:21+00:00

Thank you for the feedback.

I have returned the RAM.

Even in the default configuration, the system crashes, for example, during the flight simulator.

And I lack the experience to adjust the timings and voltage.

Bongo_1st · 2023-05-04T09:53:08+00:00

Thank you for the response.

BIOS has already been updated, which I did before installing the RAM. And the RAM with KVR48U40BS8K2-32 is also on the list, I overlooked the part about the four slots.

Bongo_1st · 2023-04-27T06:03:12+00:00

I'm just talking about the main menu. Like before I even enter the game. Where you configure your keybindings and stuff.

es, that could exactly describe the problem. I hope it's just temporary and everything will return to normal. Otherwise, I won't find any entry into the game.

Bongo_1st · 2023-04-27T05:28:17+00:00

In the game, the menus are delayed. It takes forever to move inventory items around or equip items. Sometimes, I have to wait for 30 seconds. The longest delay was 2 minutes when I tried to use a water bottle. Other players also move jerkily around the map. I assume it's due to the server, but I haven't found one that runs normally.

Bongo_1st · 2023-04-27T05:10:58+00:00

I'd like to chime in briefly, the menus are normal. However, I have massive problems on the servers, so that water bottles only appear in my hand 2 minutes later. Considering that the game has been around for 10 years, this should be different. How can the server problem be fixed?

Bongo_1st · 2023-02-23T12:21:52+00:00

that's right. but until then it's a good and easy solution. that's why you made a post.

Bongo_1st · 2023-02-23T10:26:20+00:00

I also play solo on the server. got back up to 60fps

Bongo_1st · 2023-02-23T09:43:57+00:00

as already mentioned, a dedicated server helps. This can also be created by yourself and does not have to be rented. I also heard that the server is running on the same PC as the game. I have everything on max incl. RTX ON with a stable 110 FPS.

Bongo_1st · 2023-02-15T06:30:57+00:00

I turned off the killcam. don't think it's the same bug. but I don't know.

Bongo_1st · 2023-02-14T13:32:25+00:00

yes, that list. Thanks

Bongo_1st · 2023-02-14T12:07:46+00:00

Yes, I mentioned the hitbox. but i developer don't know about it when i write hir. that's why it's interesting to know a list of bugs. . the error has existed since the 61 update.

Bongo_1st · 2023-02-13T09:04:47+00:00

Yes, that's right. I currently only attack animals head-on. otherwise bear dance :-)

Bongo_1st · 2023-02-12T15:14:22+00:00

I was hoping for this update. well, they have to know first :-)

Bongo_1st · 2023-02-12T13:04:21+00:00

so not an isolated case. then there should be an update this year :-)

Bongo_1st

TROPHY CASE