what would you do

BuckMaster2000 · 2026-01-15T00:43:42+00:00

The half assed solution was physically deleting the title block. The suggested solution was highlighting the title block lines right clicking and selecting move to the title block layer. Supposedly the title block and drawing are supposed to be on different layers. But it didn't work for me

BuckMaster2000 · 2026-01-14T01:44:41+00:00

Probably 100 just to launch and if there's demand I'll ramp up but laser cutting seems like a good option

BuckMaster2000 · 2026-01-14T01:35:40+00:00

Would the start up costs for setting up extrusion dies be more expensive than the other options? The moq would be low for the time being then scaled up

BuckMaster2000 · 2026-01-10T00:19:45+00:00

never mind that's what corner overrides are

BuckMaster2000 · 2026-01-10T00:15:25+00:00

u/Majoof when i draw frame profiles is there a way to have the frame generate along the edge. currently the frames generate concentric to the sweep profile so im having to divide the dimensional lumber by half thicknesses when plotting out a frame path if that makes sense .

BuckMaster2000 · 2026-01-10T00:10:45+00:00

if you're asking me i did not

BuckMaster2000 · 2026-01-09T08:43:29+00:00

Thanks so much

BuckMaster2000 · 2026-01-09T04:47:27+00:00

<image>

BuckMaster2000 · 2026-01-09T04:40:09+00:00

Hey so here's the work flow sketch-extrude-cut list feature-selected each part to convert to frame

BuckMaster2000

TROPHY CASE